Turbidity Measurement; Selecting The Measurement Mode - LABBOX Metria M10 Manual De Instrucciones

4. Insert the calibration standard into the measurement chamber, the mark on the vial cap aligns with the arrow on the meter.
Close the light
shield lid.
5. Press the Enter key, the meter begins the calibration. The Calibration icon continuously flashing.
6. Wait for the reading to stabilize, the meter will show the next calibration point.
If necessary, press the ► key to select a desired calibration point.
7.
8. Repeat steps 2 through 5 until the meter shows

To exit the calibration mode without saving the calibration, press the Meas key.

Turbidity Measurement

Selecting the measurement mode

The METRIA M10 portable turbidity meter contains two measurement modes. If the single measurement mode is enabled, the
meter will automatically recognize a stable reading and lock the measurement. If the continuous measurement mode is enabled,
the meter will continuously updating the measured values.
1. Press and hold the
Press the ► key until the display shows
2.
3. Press the Enter key, the display shows
Press the ► key, the display shows
4.
5. Select one of the above options, press the Enter key to confirm.
Measurement
An accurate turbidity measurement depends on good measurement techniques. Factors such as clean sample vials, positioning
of vial in the
Arrow
key for 3 seconds to enter the setup menu.
/
/
/
. Calibration is completed.
(Hold/Page 5).
indicating that the single measurement mode is selected.
indicating that the continuous measurement mode is selected.