Uline H-2590 Guia De Inicio Rapido página 3

WEEKLY
Wipe feed rollers and blade with proper solvent to
remove adhesive build-up.
No power light / tape does not feed.
Tape does not feed when unit is in
auto mode.
Blade sticks in closed position
Tape is not cut all the way through
If the troubleshooting section does not resolve your problem, contact ULINE Customer Service at 1-800-295-5510.
PAGE 3 OF 9
TROUBLESHOOTING
OPERATING ISSUE
MAINTENANCE
MONTHLY
Apply silicone oil to #242 blade roller. Inspect pressure
rollers and cutting blade for wear.
RECOMMENDATIONS
Unplug unit and plug in again.
Turn power switch off, wait 5 seconds, turn unit back on.
Check that front panel is closed securely, and safety
interlock is engaged.
Verify that the fuse has not blown.
Check that Tape Length Display is 40 mm or greater.
Check that Auto/Manual Switch is in correct position.
Turn Interval Knob all the way counterclockwise.
Wait 1 full second after tape is cut before removing tape
from machine.
Apply silicon oil to #242 Blade Roller.
Replace #279 blade with #279S serrated blade.
1-800-295-5510
uline.com
0621 IH-2590