Publicidad
Idiomas disponibles
Idiomas disponibles
English
Remote Control Functions (Fig.1)
Delay - Off
Blower Speed Decrease and Off
Blower Speed Increase and On
Light
Press
(Delay) and
Reset Filter Alarm.
CAUTION RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE. DISPOSE OF USED BATTERY IN
ACCORDANCE WITH LOCAL REGULATIONS.
FCC ID: QUS-BESMARTNEW
IC: 11613A-BESMARTNEW
• Changes or modifi cations not expressly approved by the
party responsible for compliance could void the user's
authority to operate the equipment.
• This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired
operation.
• This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not
cause interference, and (2) this device must accept any
interference, including interference that may cause
undesired operation of the device.
LINKING PROCEDURE
- The remote must be linked to the range hood in order to
work properly.
- This procedure is also useful if there are two or more products
that can be controlled by means of remote control. For
example, in apartments with adjacent kitchens, showrooms,
INDICATOR
LIGHT
FIG. 1
(Light) buttons together to
fairs, etc.
- If the remote is included with the range hood, this linking
procedure will have already been completed at the factory.
1 -
Determine the hood control from list below.
and
buttons on the remote simultaneaously
2 -
Press
for 5 seconds, until the remote control Indicator Light
turns on. Release
release
button to confi rm the linking. At this point
the remote control Indicator Light starts fl ashing to
confi rm the link is active.
3 -
Within 3 seconds press and release the Link Confi rm
button on the hood control (see below).
HOOD CONTROLS
Hood Control 1
LINK CONFIRM BUTTON - P1
Hood Control 2
LINK CONFIRM BUTTON - P5
Hood Control 3
LINK CONFIRM BUTTON - P2
Hood Control 4
LINK CONFIRM BUTTON - P1
Hood Control 5
LINK CONFIRM BUTTON - P3
Hood Control 6
LINK CONFIRM BUTTON - A
Note: To complete link, press and hold "link confi rm button
A" until hood user interface light intensity indicator 1 and 3
fl ash 3 times.
S
PEED
1
2
3
4
A
B
Hood Control 7
LINK CONFIRM BUTTON - P5
Note: To complete link, press and hold "P5" for 2 seconds.
P1
P2
P3
buttons. Press and
and
L
IGHTING INTENSITY
1
2
C
D
E
P4
P5
P6
P7
3
Publicidad
