Steren MOR-48N Manual De Instrucciones

Before using your new Aluminum Rack, please read this Before using your new Aluminum Rack, please read this
instruction manual to prevent any damage. Put it away in a safe instruction manual to prevent any damage. Put it away in a safe
place for future references. place for future references.
Your new rack is made in extruded aluminum. Complies with EIA
standard. Finished in high quality black electrostatic paint-sprayer
plated. Includes all necessary pieces for installation.
PACKAGE CONTENT
• 2 bases (angles)
• 2 posts
• 2 tops
• 12 3/8" hex head screws (16ncx1")
• 12 3/8" hex nuts
• 12 3/8" lockwashers
• 24 3/8" fl at washers
This Steren product is warranted under normal usage against defects in
workmanship and materials to the original purchaser for one year from the date
of purchase.
1.- This warranty card with all the required information, invoice or purchase
ticket, product box or package, and product, must be presented when
warranty service is required.
2.- If the product stills on the warranty time, the company will repair it free of
charge.
3.- The repairing time will not exceed 30 natural days, from the day the claim
was received.
4.- Steren sell parts, components, consumables and accesories to costumer, as
well as warranty service, at any of the addresses mentioned later.
THIS WARRANTY IS VOID IN THE NEXT CASES:
If the product has been damaged by an accident, acts of God, mishandling, leaky
batteries, failure to follow enclosed instructions, improper repair by unauthorized
personnel, improper safe keeping, among others.
a) The consumer can also claim the warranty service in the purchase
establishment.
b) If you lose the warranty card, we can reissue it, if you show the invoice or
purchase ticket.
RETAILER INFORMATION
Name of the retailer
Address
Product
Brand
Part number
Product: Aluminum Rack
Part number: MOR-48(N), MOR-84(N)
Brand: Steren
WARRANTY
CONDITIONS
To install your new rack, follow these instructions:
1.- Carefully, unpack the pieces.
2.- Place bases on the fl oor, then put the posts over the bases. Use the
hex head screws to fasten them.
3.- Install the tops and fasten them with the screws.
4.- Finally install the bases in the fl oor, fasten them tightly.
We recommend to place a lockwasher between the head of the We recommend to place a lockwasher between the head of the
screw and the fl at washer. screw and the fl at washer.
SPECIFICATIONS
Extruded aluminum, 6061 T6 alloy
Dimensions MOR-48(N): 19 x 48in
Dimensions MOR-84(N): 19 x 84in
Product design and specifi cations are subject to change, without Product design and specifi cations are subject to change, without
notice. notice.
Serial number
Date of delivery
In case your product fails or have any doubt, please contact your
nearest retailer. If you are in Mexico, please give a call to our Call Center.
Call Center
01 800 500 9000