Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Leveling the Appliance
• For sufficient leveling and air circulating in
the lower rear section of the appliance.the
bottom feet may need to be adjusted. You
can adjust them manually by hand.
• To allow the doors to self-close, tilt the top
backwards by 3/8-5/8 inches (l O-l 5mm).
3/8 "-5/8 " ( l0mm-l 5mm)
Adjus able
bottom feet
=
Adjustable bottom feet
Tools you may need
OJ
)))
Philips
Screwdriver
Not
provided
C§:E===
Slotted
Screwdriver
�
Provided
Allen Wrench
(5/32", 4mm)
, ,
a
Rea roller
=--'l
�
Socket Wrench
(5/16", 8mm)
c?
Putty Knife
Reversing the Fridge Door
The side at which the door opens can be
changed, from the right side (as supplied)
to the left side, if the installation site
requires.
A
warning!
When reversing the door, the appliance must
not be connected to the mains. Ensure that
the plug is removed from the power socket.
Note:
When required, tilt the refrigerator back in
order to gain access to the base, you
should rest the appliance on soft foam
packaging or similar material to avoid
damaging the backboard of the
refrigerator. To reverse the door, the
following steps are generally
recommended.
l . Stand the refrigerator upright. Open the
upper door to take out all door racks (to avoid
damag ed racks) and then close the door.
1 1 � ;1.�- � -���- J . J i 1
J�
2. With the door closed, remove screws (you
can pry it up with a Philips Screwdriver) and the
upper hinge cover (you can pry it up with a
Slotted Screw driver) (E) on the top right side
of appliance and remove 3 special flange
screws (F) with a Socket Wrench. Keep the
upper hinge cover for future reference.
8
Publicidad
Tabla de contenido
