Ryobi AC4DRT Manual Del Usuario

AUGER BITS
LES EMBOUTS DE TARIÈRE
PUNTAS DE LA BARRENA
AC4DRT/AC6DRT/AC8DRT/AC10DRT
For use with Ryobi™ P2903 and RY40701 Hole Augers.
NOTE: These instructions supplement the ASSEMBLING THE HOLE
AUGER instructions in your operator's manual.
WARNING:
This insert sheet is not a substitute for reading the operator's manual.
To reduce the risk of injury or death, user must read and understand
operator's manual before using this product.
WARNING:
To prevent accidental starting that could cause serious personal injury,
always remove the battery pack from the product when assembling parts.
ASSEMBLING THE HOLE AUGER
See Figures 1 - 2
n Stand the auger bit (B) upright with tip pointing down.
n Remove the locking pin (A) from the auger (B).
n Install the drive shaft (D) into the auger (B).
n Align the holes on the auger (B) and drive shaft (D).
n Insert the locking pin (A) and secure with the pin clip (C).
Please consult your operator's manual for further information or contact
Ryobi Customer Service at 1-800-525-2579.
TECHTRONIC INDUSTRIES POWER EQUIPMENT
P.O. Box 1288, Anderson, SC 29622 USA n 1-800-525-2579 n www.ryobitools.com
Model/item number on product may have additional letters at the end. These letters designate
manufacturing information and should be provided when calling for service.
998000430
10-28-20 (REV:01)
Fig. 1
C
Fig. 2
C
B
A
B
A
D