Intermatic WP1000 Serie Manual De Instrucciones

WP1000 SERIES GUARDIAN
WEATHERPROOF RECEPTACLE COVERS
This GUARDIAN weatherproof cover can be used outdoors or in other wet
locations (protects receptacles while in use for unattended applications). The
cover is UL listed and meets the requirements for all outdoor low voltage
landscape lighting as defined by UL 1838. It also meets UL and CSA Cold Impact
Testing at -60°F (-51°C), is CSA certified, NEMA 3R rated and meets National
Electrical Code requirements covered by Article 406.8(B).
Contents
The following items are included:
• Weatherproof cover, base and gasket
• Toggle, round, GFCI and duplex inserts
• Baggie assembly with mounting hardware
Models
These instructions cover these models:
WP1000C Single gang - Vertical
WP1010C Single gang - Vertical
WP1000HC Single gang - Horizontal
WP1010HC Single gang - Horizontal
Installation
Follow the steps listed at right while referring to the illustrations below.
CAUTION: IF USING A POWER SCREW-DRIVER, BE CAREFUL NOT TO OVER-
TIGHTEN SCREWS–YOU WILL STRIP THE THREADS ON THE JUNCTION BOX AND/
OR ELECTRICAL DEVICE.
1. DISCONNECT POWER to the receptacle at the circuit breaker panel before
installing.
2. If installing on an existing receptacle, remove the existing cover/gasket and
discard.
3. Select the right insert for the application and press into bass. If you need to
remove the knock-outs on the round insert, grab them from the back with a p l i -
ers and pry down until they break free. If using the round insert, knock
out the appropriate hole size (see Knockout Removal).
4. The base should be installed on a smooth, flat surface. To ensure a weather-
proof seal on surfaces such as brick or cedar siding, a 1/4" bead of non-
hardening silicon caulk should be placed between the gasket and mounting
surface.
5. Mount the base/insert assembly and the receptacle(s) to the junction box
using two of the long screws provided. To ensure weatherproof protection,
the hinges must be located at the top with the cord on the bottom. If mount-
ing to an outdoor junction box or FS box, use the remaining long screws to
further secure the base/insert assembly to the junction box, using the exist-
ing holes. For specially designed boxes, mounting holes should be drilled to
line up with the holes in the box.
7. Be sure all screws are secure but not over-tightened. Install the remaining
short screws into the receptacle as required
8. To open, bend back the plastic latch while lifting the cover. A hasp is
provided for padlocking (see right).
FOR BEST PROTECTION FROM RAIN OR HUMIDITY, BE SURE TO ROUTE THE CORDS
THROUGH THE CORD KNOCKOUTS IN THE COVER AND PRESS THE COVER FIRMLY
UNTIL IT SNApS CLOSED OVER THE HASp.
DO NOT USE IF INCORRECT CORD KNOCKOUTS ARE REMOVED.
Caution: DisConneCt power to the
DeviCe at the CirCuit breaker panel
before installing this reCeptaCle
Cover.
INTERMATIC INCORPORATED,
CorD
outlets
GFCI
HORIZONTAL
CorD
outlets
GFCI
VERTICAL
Includes these inserts
Vertical or horizontal installation
Only for use with GUARDIAN Weatherproof covers
limited one Year warranty
If within one (1) year from the date of purchase, this product fails due to a defect in material or workmanship,
Intermatic Incorporated will repair or replace it, at its sole option, free of charge. This warranty is extended to the
original household purchaser only and is not transferable. This warranty does not apply to: (a) damage to units
caused by accident, dropping or abuse in handling, acts of God or any negligent use; (b) units which have been
subject to unauthorized repair, opened, taken apart or otherwise modified; (c) units not used in accordance with
instructions; (d) damages exceeding the cost of the product; (e) sealed lamps and/or lamp bulbs, LED's and
batteries; (f) the finish on any portion of the product, such as surface and/or weathering, as this is considered
normal wear and tear; (g) transit damage, initial installation costs, removal costs, or reinstallation costs.
INTERMATIC INCORPORATED WILL NOT BE LIABLE FOR INCIDENTAL OR CONSEQUENTIAL
DAMAGES. SOME STATES DO NOT ALLOW THE EXCLUSION OR LIMITATION OF INCIDENTAL OR
CONSEQUENTIAL DAMAGES, SO THE ABOVE LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
THIS WARRANTY IS IN LIEU OF ALL OTHER EXPRESS OR IMPLIED WARRANTIES. ALL IMPLIED
WARRANTIES, INCLUDING THE WARRANTY OF MERCHANTABILITY AND THE WARRANTY OF FITNESS
FOR A PARTICULAR PURPOSE, ARE HEREBY MODIFIED TO EXIST ONLY AS CONTAINED IN THIS
LIMITED WARRANTY, AND SHALL BE OF THE SAME DURATION AS THE WARRANTY PERIOD STATED
ABOVE. SOME STATES DO NOT ALLOW LIMITATIONS ON THE DURATION OF AN IMPLIED WARRANTY,
SO THE ABOVE LIMITATION MAY NOT APPLY TO YOU.
This warranty service is available by either (a) returning the product to the dealer from whom the unit was
purchased, or (b) mailing the product, along with proof of purchase, postage prepaid to the authorized service
center listed below. This warranty is made by: Intermatic Incorporated/After Sales Service/7777 Winn Rd.,
Spring Grove, Illinois 60081-9698/815-675-7000 http://www.intermatic.com Please be sure to wrap the product
securely to avoid shipping damage.
SPRING GROVE, ILLINOIS 60081-9698
DUPLEX
HORIZONTAL
loCkable
tab
DUPLEX
VERTICAL
Knockout removal
158wp11822