Correct Use; Using The Equipment; Use / Safety Information - Brill PowerAccu 24 PA Manual Del Usuario

4. Correct Use

Only charge the Brill Power
Accu 24 PA with this charger.
5. Using the Equipment for the First Time
Plug the mains plug (1) into the
socket and the equipment plug
(2) in to the connection socket
of the Power Accu, Correct
connection starts the charging
process automatically (5 red
LED lights up).
If a defined discharge of the
Power Accu is required, this
can be undertaken at any time
by pressing the yellow push-
button (7) (5 red LED goes out,
4 yellow LED light up).
The discharging process can be
interrupted at any time in the
6. Information on Correct Use / Safety Information
The duration of the
A
discharging process is
dependent on the level of
charge and the capacity of the
Power Accu connected. The
charging time can also vary
depending on the residual capa-
city present in the Power Accu.
Adherence to the operating
instructions supplied by Brill is
the precondition for the correct
use of the equipment.
same way by pressing the
yellow pushbutton (7) and
the charging process can be
started again.
If the Power Accu has reached
the optimum discharge point,
the charger starts the charging
process automatically.
The end of charging is detected
automatically by the charger.
The charger switches over to
maintaining the charge when
charging ends (5 red LED goes
out, 6 green LED goes on).
Protect the charger from
A
moisture.
Do not use the charger as
A
a DC power source for
electrical equipment of any kind
whatsoever.
GB
13