Tripp-Lite B110-SP-POE Guia De Inicio Rapido página 4

Installation
Multiple Device Protection:
Note: The max distance between any two In-Line 1G PoE Surge Protectors is 328 ft.
(100 m).
1. Disconnect the installed patch cable from both of the devices you wish to
protect.
2. Connect an In-Line 1G PoE Surge Protector to each end of the previously
uninstalled patch cable, ensuring both ends of the patch cable are
connected to the "Cable End" of the In-Line 1G PoE Surge Protector.
3. Using Cat5/5e/6 patch cables (not included), connect the "Equipment
End" of each In-Line 1G PoE Surge Protector to the PoE device and
equipment you wish to protect.
Note: For the best protection performance, the Cat5/5e/6 patch cable between
the "Equipment End" of the In-Line 1G PoE Surge Protector and the PoE
equipment to be protected should not exceed 300 ft. (90 m). Tripp Lite's
N001-Series Cat5e Snagless Patch cables are recommended.
4. Connect the ground wire to each In-Line Surge Protector and then to earth
ground.
PoE Equipment
(Protected)
Equipment End
Cable End
20-06-208 93-38D3.indb 4 20-06-208 93-38D3.indb 4
IP Phone PoE Camera
OR
328 ft.
(100 m) Max
PoE Sources
(Protected)
OR
PoE Hub PoE NVR
4
Cable End
Equipment End
7/19/2021 11:10:52 AM 7/19/2021 11:10:52 AM