Pixel Voical Air Guia Del Usuario página 5

Operation and use
3.The receiver is installed on the phone for use, as shown in
the picture below.
3. Turn on the power
Press it 2s for start-up/shut down; lightly press it once to
activate / deactivate the mute:
4. Setting
1.The function setting key is used to set the signal channel
numbers of the transmitter and the receiver to the same.
Signal channel numbers.
Adjusting method: press "
character flashes on the display screen (the same signal
channel is also accordingly set for the receiver), the signal
channel numbers can be adjusted by pressing the key, after
the adjustment is completed, press the "
to quit and save the setting, or wait for 3s, automatically quit
and save the setting.
6
" SET setting key, when "CH**"
" SET key again
Operation and use
For example: for A channel, the signal channel of the
transmitter is set as CH01 and the signal channel of the
receiver is set as CH01; the schematic diagram is as follows:
2. The DB sensitivity of the transmitter can be directly
adjusted by pressing "-" "+" keys, after the adjustment is
completed, the satisfactory sound effect is obtained.
3. The monitoring volume of the receiver can be directly
adjusted by pressing "-""+" keys, after the adjustment is
completed, the satisfactory sound effect is obtained.
5. Charging
When the battery capacity is low, it shows red, during
+
charging, the lightning sign is shown and the charging grid
runs slowly, after the battery capacity is full, the charging grid
stop running.
After using Type-C interface 5V 1A input, the microphone can
+
work continuously.
7