Care And Cleaning; Troubleshooting - Glacier bay 3075-512-WS1 Guía De Uso Y Cuidado

Installation (continued)
3
Installing the shower arm
 Insert a gasket (AA) between the end of the adjustable
shower arm (B) and the wall shower arm (3.1).
 Turn the mounting nut (3.2) on the adjustable shower arm
(B) clockwise to tighten, but do not overtighten.
 Once installed, tighten the set screw (3.3) on the mounting
nut (3.3) using the Allen wrench (CC).
4
Installing the showerhead
 Insert a gasket (AA) between the showerhead (A) and the
adjustable shower arm (B). Hand tighten the showerhead
(A), but do not overtighten.
 Turn on the water and check for leaks. If leaks occur,
retighten connections or reinstall using more thread
seal tape (BB).

Care and Cleaning

 Clean periodically with a soft cloth.
 Avoid abrasive cleaners, steel wool, and harsh chemicals as these will dull the finish and void your warranty.

Troubleshooting

PROBLEM POSSIBLE CAUSE
There is low water pressure or a The showerhead spray nozzles are clogged.
missing spray pattern.
Debris has clogged the shower arm or showerhead.
The shower arm/showerhead Showerhead connection is loose.
connection is leaking.
There is leaking at the Shower arm connection is loose or thread seal tape is
connection between the not creating a good seal.
adjustable shower arm
and wall shower arm.
B
A
SOLUTION
Soak the showerhead in a solution of water and vinegar. Use a solution of 50% white vinegar
and 50% water overnight. The vinegar will break down any mineral deposits or sediment from
hard water and should improve the flow through your showerhead.
Remove the showerhead and rinse debris from internal parts.
Turn on the hot and cold water and let it run for at least 30 seconds to flush debris from the lines.
Reinstall the showerhead.
Gently and firmly tighten the showerhead, but do not overtighten.
Retighten the adjustable shower arm to the wall shower arm.
If the leak continues, remove the adjustable shower arm from the wall shower arm to confirm
thread seal tape was applied properly. Remove and reapply thread seal tape, if needed.
4
3.1
AA
3.2
CC
3.3
B
AA