▪
The operator or user is responsible for accidents or hazards occurring to other people or
their property.
▪
Only use a weather proof extension cord fitted with a coupler according to I EC 60320-2-3.
▪
Disconnect the appliance from the mains supply :
O
Whenever you leave the machine,
before clearing a blockage.
O
before checking, cleaning or working on the appliance,
O
O
if the appliance starts to vibrate abnormally.
▪
Keep all cooling air inlets clear of debris.
▪
Maintenance and storage :
O
Keep all nuts, bolts and screws tight to be sure the appliance is in safe working
condition.
Check the debris collector frequently for wear or deterioration.
O
O
Replace worn or damaged parts.
O
Use only genuine replacement parts and accessories.
O
Store the appliance only in a dry place.
▪
While operating the appliance, always wear substantial footwear and long trousers.
▪
Wear protective goggles while operating.
▪
Wearing hearing protection during periods of extended operation is recommended
▪
Never operate the appliance with defective guards or shields, or without safety devices, for
example debris collector in place.
7
ASSEMBLY
Your new electric blower vac requires very little assembly work before it is ready for use.
7.1
Assembling the tubes (Fig. 2.1- 2.6)
1. Slide the rear blow/suction tube(3) into the suction/blower housing and make sure it fits
correctly and is fully inserted.
2. Secure it on both sides of the suction/blower housing with the one 75mm screws provided.
3. Insert the Whell support (1) into the front suction/blower tube(2) and make sure it fits correctly
and is fully inserted.
4. Secure it with the Whell support screw provided
5. Insert the he front suction/blower tube(2) into the rear blow/suction tube(3). Make sure they
fit properly and are fully inserted.
6. Secure both with the 45mm screws provided.
7.2
Assembling the collection bag support (Fig. 3)
Insert the collection bag support (8) into the fcollection bag (9) and make sure it fits correctly and
is fully inserted.
Secure it with the string belt on collection bag has been tightened.
7.3
Fitting the collection bag (Fig. 4.1 - 4.4)
Before fitting the collection bag (9) ensure that the Vacuum/Blow selector lever of the additional
adjustable handle(4) operates smoothly and that it is not obstructed by debris from previous use.
Locate the collection bag and fold back the opening with the adaptor connection inserted into
the holes on both sides of the discharge opening. Attach the front of the debris collection bag
to the underside of the suction-blower tube using the clip fitted to the collection bag.
11
www.hortensus.eu