Cleaning And Maintenance; Troubleshooting - Hortensus BVM-9SPK-850 Manual Del Usuario

10

CLEANING AND MAINTENANCE

Attention! Before performing any work on the equipment, pull the power plug.
Keep the ventilation slots of the tool clean to prevent overheating of the engine.
Regularly clean the tool housing with a soft cloth, preferably after each use.
If the dirt does not come off use a soft cloth moistened with soapy water.
Never use solvents such as petrol, alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
11 STORAGE
Never leave material in the blower-vac suction tube or collection bag.
12 TROUBLE SHOOTING
Please check below chart for the observed symptoms to solve problems with your machine
Problem
The engine does not
start
The machine does not
blow
The machine does not
vacuum
If the problem cannot be solved using above chart than please contact your after sales agent.
Possible Cause
The machine is not connected
to the mains
Damaged cable
The machine is not completely
mounted
Damaged switch
The lever of the machine is on
vacuum mode.
Ventilator obstructed.
Tubes obstructed
The lever is on blowing mode.
Ventilator obstructed.
Tubes obstructed.
Action
Plug the machines to the
mains.
Take the machine to the
after sales agent. Never
repair the cable with tape.
Mount the tubes and the
catcher.
Take the machine to the
after sales service
Put the lever on the blowing
position.
Remove the tube and clean
the ventilator.
Clean the tubes
Put the lever on the vacuum
position.
Remove the tube and clean
the ventilator.
Clean the tubes
www.hortensus.eu
14