Honeywell SV2 Serie Instrucciones De Instalación página 8

5 PROGRAMMING AND SETUP
Refer to document 32-00031 (SV2 Series HMI/PC Tool User Manual) for
detailed valve programming instructions.
The SV2 Series valve's intelligent features are programmed via the use of
the HMI or PC Tool (HMITOOL-000 or PCTOOL-000). The programmable
features, which are model dependent, include:
• Valve Modbus address + communication speed
• Low gas pressure switch setting and reset type
• High gas pressure switch setting and reset type
• VPS (valve proving system) operation
• Fuel/air firing curve
• Leak detection sequence
• Fuel metering functionality
IMPORTANT
- You DO NOT have to enable and utilize the intelligent valve features.
- Any intelligent features used do require completion of setup and verification during the initial valve setup using the HMI or PC tools
before the valve will be operational.
- When using the Pressure Module, you MUST use both the low gas pressure and high gas pressure settings.
When Programming With This Product....
1. The HMITOOL has embedded guided setup features to guide you safety through the setup and commissioning process.
Safety, however, is your responsibility.
2. Read all documentation carefully and respond appropriately to all fault and warning messages.
3. Refer to document 32-00031 (SV2 Series HMI/PC Tool User Manual) for detailed valve programming instructions.
4. Make sure the HMI 8-pin connector is properly aligned and pressed firmly in place.
5. Make sure the wires between the 8-pin connector and the SV2 valve(s) are properly wired and secured.
6. Make sure the power supply is connected securely to the power source.
WARNING
Electrical Shock Hazard.
Can cause severe injury, death or equipment damage.
Line voltage is present at the 120VAC or 240VAC power supply.
WARNING
Explosion Hazard.
Improper fuel/air configuration can cause fuel buildup and explosion.
Improper user operation may result in PROPERTY LOSS, PHYSICAL INJURY or DEATH.
Installing and using the HMI display to setup or change parameters must be attempted
combustion service technicians.
This device must be setup according to all applicable national and local codes, ordinances and regulations.
8
only by trained and experienced
32-00030EFSP—05