Ibx HM01 Manual Del Usuario página 8

clockwise until you reach the desired speed.
•
Placing the thermometer: Assemble the two parts of the rod and insert the rod in its support at the back
side of the equipment. Once the rod is placed, put the bosshead at the desired height, hold it with the
screw and put the thermometer clamp.
6.3. HM01-D: Digital Heating Mantle
•
Place the heating mantle on a horizontal, flat, and stable surface leaving at least 30cm clear on each
side. Do not place it near any heat source.
•
Connect the equipment to a power source.
•
Set up the temperature sensor rods on the rod support. Place the sensor in the sample.
•
Press the S button to go to set-up mode. Use the arrows to adjust the temperature. The digital screen
displays the temperature set by the user.
•
Press the S button to go back to working mode. The digital screen now displays the actual temperature
of the sample.
6.4. HM02-D: Digital Heating Mantle with Stirring
•
Place the heating mantle on a horizontal, flat, and stable surface leaving at least 30cm clear on each
side. Do not place it near any heat source.
•
Connect the equipment to a power source.
•
Set up the temperature sensor rods on the rod support. Place the sensor in the sample.
•
Press the S button to go to set-up mode. Use the arrows to adjust the temperature. The digital screen
displays the temperature set by the user.
•
Press the S button to go back to working mode. The digital screen now displays the actual temperature
of the sample.
•
Turn the knob clockwise and anticlockwise to adjust the magnetic stirrer power.
Note:
• The power used must match the device's requirements.
• Adjust the power gradually and slowly.
• Make sure the power line is at a safe distance from the
heating mantel.
• In case of any fault, cut off the electricity immediately.
Note:
• The power used must match the device's requirements.
• Make sure the power line is at a safe distance from the
heating mantel.
• In case of any fault, cut off the electricity immediately.
Note:
• The power used must match the device's requirements.
• Adjust the power gradually and slowly.
• Make sure the power line is at a safe distance from the
heating mantel.
• In case of any fault, cut off the electricity immediately.
8