Troubleshooting - Aqua EZ RPV5 Manual Del Usuario

How to remove the battery pack
Recommended tools (not included): Philips screwdriver and small slot screwdriver
1. Turn to release the canopy and take out the filter bag / filter cage. Use a small slot screwdriver to detach the ring from the handle. If it is too
difficult to detach the ring with a screwdriver, use a cutting plier to cut. Turn the switching knob to open the charging port. Use the small slot
screwdriver to pry and detach the middle cover from the switching knob. Use the Philips screwdriver to unfasten the knob-locking screw.
2. Detach the switching knob and use the Philips screwdriver
to unscrew all the screws on the main body. Separate the
body in two halves to access the main chamber.
4. Remove the complete battery enclosure (with battery installed) from the chamber. In order to detach the battery cable, press on the clip on
the connector and pull the cable out. Wrap the connector immediately with insulating tape in order to avoid short circuit caused by the
contact of both wire terminals.

TROUBLESHOOTING

Problem
Electric vacuum does
not capture the debris
Debris escapes from the filter
Debris escapes from the
filter bag / filter cage
Electric vacuum cannot
be charged / recharged
Pivoting suction head
(if provided) does not
move smoothly
Environmental Programmes, WEEE European Directive
Please respect the European Union regulations and help to protect the environment.
Return non-working electrical equipment to a facility appointed by your municipality that properly
recycles electrical and electronic equipment. Do not dispose them in unsorted waste bins.
For items containing removable batteries, remove batteries before disposing of the product.
© 2019 Aqua EZ inc.
All rights reserved. No part of this document may be reproduced or transmitted
in any form or by any means, electronic, mechanical, photocopying, recording,
or otherwise, without prior written permission of Aqua EZ inc. (V1)
Possible Cause Solution
Battery is drained Charge the battery again.
Impeller is jammed
Power off the electric vacuum and inspect the middle gap of the electric vacuum
to see if the impeller is jammed by larger debris. If possible, use a small tool to
remove it with intensive care & caution. If necessary, contact your dealer for
further instructions.
WARNING!
unit is being serviced.
Impeller is broken
Contact an authorized dealer regarding replacements.
Filter is full Clean the filter.
Canopy flap is damaged Canopy flap works like a door to prevent the debris from escaping from the filter.
Contact dealer for replacement part and instructions.
Filter bag / filter cage is Replace with a new filter bag / filter cage. Contact an authorized dealer regarding
damaged. replacements.
Battery is damaged Contact an authorized dealer regarding replacements.
WARNING!
by yourself. This could result in severe or fatal injuries, as well as voiding
the warranty.
USB cable is damaged Replace with a new USB cable.
Replace with a new USB charger.
USB charger (not
included) is out of order
Wheel is jammed Clean out the debris from the wheel.
Note: Do not attempt to take out the wheels.
3. Use the Philips screwdriver to unfasten the screws. Remove the
top half of the chamber to expose the battery enclosure.
Make sure the electric vacuum is powered off when the
DO NOT open the electric vacuum and replace the battery
If parts or Technical support is required, please
contact our customer service by email or phone
SAVE THESE INSTRUCTIONS
C US
info@aquaez.com 1-877-852-4264
Distributor: Aqua EZ inc.
6100 Wheaton Dr. SW
Atlanta, Ga 30336 USA