Garden Treasures C864-62 Manual Del Usuario página 4

ASSEMBLY INSTRUCTIONS
3. a) Insert three screws (AA) into the holes at the end of center
post (B) and tighten.
b) Insert the plug end of the power cord out of the
bottom of the fountain through the center of base (D).
Place the holes in the base (D) over the screws (AA).
c) Attach a washer (BB) and a nut (CC) to the ends of each
screw (AA) and tighten.
Hardware Used
AA
M8 x 30 Screws
BB M8 Washers
M8 Hex Nuts
CC
4. a) Turn the assembly upright. Make certain the preassembled
pump has been adjusted to "middle" water fl ow position.
b) Screw the large pipe (EE) on top of the pump mounting
bracket inside the bowl and pump assembly (A) and tighten.
c) Place the large bottom spacer (E) over the pump mounting
bracket and at the same time pull the LED lights through the
slots provided in the bottom of spacer (E) so that the LED
lights lay evenly spaced 3 to 4 inches from spacer (E) in the
bottom of the bowl (A). Make sure that the LED light wires
are in the slots provided before tightening. Arrange large top
spacer (F) on top of the large bottom spacer (E). Arrange the
center bowl (G) on top of the top bottom spacer (F).
d) Insert the rubber gasket (FF) and the plastic washer (GG)
on top of the center bowl (G) over the large pipe (EE). Attach
the M19 plastic hex nut (HH) to the end of the connection and
tighten.
Hardware Used
205 mm
EE
Large Pipe
45 mm
FF
Rubber Gasket
32 mm
GG
Plastic Washer
M19
HH
Plastic Hex Nuts
3
AA
x 3
x 3
x 3
4
HH
GG
FF
EE
x 1
x 1
x 1
x 1
Lowes.com/gardentreasures
6
ASSEMBLY INSTRUCTIONS
5. a) Screw the small pipe (II) into the large pipe (EE) .
CC
b) Place the center bowl spacer (H) over the small pipe (II).
c) Place the small top bowl (I) on top of the center bowl
BB
spacer (H).
d) Insert the 38 mm rubber gasket (JJ) and the 38 mm plastic
washer (KK) on top of the center bowl (I) over the pipe (II).
e) Attach the M13 plastic hex nut (LL) to the end of the
D
connection and tighten.
B
Hardware Used
215 mm
I I
Small Pipe
38 mm
JJ
Rubber Gasket
38 mm
KK Plastic Washer
G M13
LL
Plastic Hex Nuts
6. a) Place the top spacer (J) on top of the small top bowl (I) over
F
the small pipe (II).
b) Tighten the top ring (K) on top of the top spacer (J).
c) Tighten the plastic nozzle (MM) on top of the small pipe (II).
d) Attach and tighten the top cap (L).
E
Hardware Used
MM
Plastic Nozzle
A
5
LL
JJ
I I
EE
x 1
x 1
x 1
x 1
6
L
MM
K
x 1
I I
Lowes.com/gardentreasures
7
KK
I
H
G
J
I