Confirmation Tone; Using Microphone Button; Power Save Mode - Amplicomms TV3500 Manual De Instrucciones

Confirmation Tone

There is a "beep" tone as confirmation for every effective key press on TV3500
remote control. Some special tone will be used for below listed case:
1. 2 beeps will be heard when the volume level is reaching the maximum or
minimum.
2. 2 beeps will be heard when the left and right sound level difference is
reaching the maximum.
3. A long beep will be heard when the left and right sound level is equal
balanced.
4. 2 beeps will be heard when EQ1 ( Flat ) is selected.

Using microphone button

In active mode, press the
transparency mode. The headset indicator will switch from blue to red. The
microphone hole is at the front of the headset to pick up the sounds of your
surroundings. Make sure that the microphone opening is not covered!.
When the microphone is switched ON, you will hear your surroundings louder.
You can hear for example your door bell or your conversational partner even
when you are wearing the headset.
To switch back to the TV listening mode, press the
headset indicator will turn to blue and you will hear the sound from the audio
source again.

Power save mode:

To save power, the headset will enter sleep mode when there is no signal
detected for approximately 5 minutes. To wake up the headset, press
button.
Note : To turn OFF the headset, press and hold the
The headset LED will turn OFF.
button will switch from TV listening mode to
23
button again. The
button for 3 seconds.