Aci Tre - Aci Quattro - fantozzi scale ACI SVEZIA Instrucciones Para La Instalación

INSTRUCTIONS FOR USE AND MAINTENANCE
1.
Open the package and leave the ladder and the stick to pull the ladder down on the access floor. Take the 4
top-fixing brackets with their relevant 10ma nuts to the landing floor.
2.
By means of supports or ropes slip the ladder inside the wall aperture from underneath. Immediately after
that, insert the 4 drilled brackets vertically into the 10ma threaded, projecting bars. Screw down the 10ma nuts
with a spanner 17 until the bottom frame beam of the ladder fits snugly to the slab (do not finally tighten it).
3.
Check the ladder (in its stowed position) from underneath and make sure there is a steady fissure between
the frame and the panel (ladder with right angles) and that anyhow the panel does not make contact with
the frame. If this is not the case, you have to adjust the ladder from the top, by means of small displacements.
Then finally tighten the ladder firmly to the slab at the 10ma nuts of the brackets by means of the spanner 17.
N.B. It is recommended to cut off the excess threaded rod from the lock nut.
4.
Use the stick ending in a hook (the stick is made up of two sections) to unstow the ladder from underneath, by
inserting the hook in the projecting ring of the panel and pulling the stick.
Then turn and extend the 3 or 4 ladder and look them with the locking lever. Make sure that the 3 or 4 sections
of the ramp are perfectly aligned aligned and that the ramp rests firmly on the floor, by screwing down or out
the 2 10ma nuts featured on the 2 tie-rods with the spenner 17.
4.1 = Rod
4.2 = Ladder's lock
4.3 = Open stick
5.
Should the ladder be adjusted for heights falling outside atandard heights, in addition to adjusting the tie rods,
you must slide the ramp by means of the 8ma nuts with a spanner 13. such nuts are featured on the slotted
plates at the base of the top section of the ramp. The ladder must not be bricked in. Just in case it is imperative
to brick it in due to unforeseen specific problems, please be careful not to soil the 2 lock nuts for ratchets and
tie rods (they must be able to rotate freely). WARNING: Don't wall up the box frame
6.
Non-slip mats.
6.1 = basic version with a series of non-slip strip to be cut to size and applied on the steps.
6.2 = elegant version with two series of non-slip strips cut to size to be applied on the steps.
ACI TRE
(see drawings p. 6 - 7 - 8)
ACI QUATTRO
(see drawings p. 6 - 7 - 8)
14