Tools Required; Mounting Options; Installing Your Fan 3 - HAMPTON BAY 705 544 Manual Del Propietário

Tools Required

Phillips screw driver, straight slot screw
driver, adjustable wrench, step ladder, and
wire cutters.

Mounting Options

If there isn't an existing outlet box, then read
the following instructions. Disconnect the
power by removing fuses or turning off
circuit breakers.
Secure the outlet box directly to the building struc-
ture. Use appropriate fasteners and build-
ing materials. The outlet box and its support
must be able to fully support the moving
weight of the fan (35 lbs. (15.9 kg) or less)
Do not use plastic outlet boxes.
THE OUTLET BOX AND SUPPORT STRUCTURE
MUST BE SECURELY MOUNTED AND CAPABLE
OF RELIABLY SUPPORTING 35 LBS. (15.9 KG).
USE ONLY UL LISTED OUTLET BOXES MARKED
"ACCEPTABLE FOR FAN SUPPORT OF 35
LBS. (15.9 KG) OR LESS."
COMMONLY USED FOR
OF LIGHTING FIXTURES
ACCEPTABLE FOR FAN
MAY NEED TO BE REPLACED. CONSULT A
QUALIFIED ELECTRICIAN IF IN DOUBT.
Figures 1, 2, and 3 are examples of different
ways to mount the outlet box.
OUTLET BOXES
THE SUPPORT
MAY NOT BE
SUPPORT AND
Outlet Box
Figure 1
Outlet Box
Figure 2

Installing Your Fan 3.

Provide Strong
Support
Recessed
Outlet Box
Note: You may need a longer downrod to
maintain proper blade clearance when install-
ing on a steep, sloped ceiling. The maximum
angle allowable is 30˚. If the canopy touches
downrod, remove the decorative canopy
bottom cover and turn the canopy 180˚ before
attaching the canopy to the mounting plate.
Outlet Box
To hang your fan where there is an existing
fixture but no ceiling joist, you may need an
installation hanger bar as shown in Figure 4
(available at your Hampton Bay retailer).
Ceiling
Mounting
Plate
Figure 3
Figure 4