Hanging The Fan - HAMPTON BAY 705 544 Manual Del Propietário

Hanging the Fan

REMEMBER
to turn
er. Follow the steps below to hang your
fan properly.
NOTE: This ceiling fan is supplied with two
types of hanging assemblies; the standard
ceiling installation using the downrod with
ball and socket mounting, and the "close-to-
ceiling" mounting. The "close-to-ceiling"
mounting is recommended in rooms with
less than 8-foot ceilings or in areas where
additional space is desired from the floor
to the fan blades. When using standard
downrod installation, the distance from the
ceiling to the bottom of the fan blades will be
approximately 11 inches. The "close-to-ceiling"
installation reduces the distance from the
ceiling to the bottom of the fan blades to
approximately 7 inches.
Once you have decided which ceiling
installation you will use, proceed with the
following instructions. Where necessary,
WHEN MOUNTING THE FAN ON A SLOPED
CEILING, THE STANDARD BALL/DOWNROD
MOUNTING METHOD MUST BE USED. THE
MOUNTING PLATE MUST BE MOUNTED SO
THAT THE SLOT OPENINGS ARE ON THE
LOWER SIDE BY SLIDING THE MOUNTING
PLATE FROM THE TOP DOWN. FOR A GREATER
MOUNTING ANGLE, REMOVE THE DECORA-
TIVE CANOPY BOTTOM COVER (FIGURE 9).
4.
each section of the instructions will note the
different procedures to follow for the two
types of installation.
off the pow-
Standard Ceiling Mounting
1. Remove the canopy ring from the canopy
by turning the ring to the right until it
unlocks (Figure 5).
Turn Canopy Ring to Remove
2. Remove the mounting plate from the
canopy by loosening the four screws on
the top of the canopy. Remove the two
non-slotted screws and loosen the slotted
screws. This will enable you to remove the
mounting plate (Figure 6).
Loosen but
Do Not Remove
3. Route the wires exiting the top of the
fan motor through the decorative motor
collar cover then the canopy ring. Make sure
the slot openings are on top. Route the wires
through the canopy and then through the
ball/downrod assembly (Figure 7).
UL Listed
Outlet Box
Slide Mounting
Plate Over
Screw Heads
Figure 5
120V Wires
Canopy
Canopy Ring
Downrod Cover
Remove
Motor Collar Cover
Hanger Pin
Figure 6
Mounting Screws
(Supplied With
Outlet Box)
Hook
Ceiling
Mounting
Plate
Motor Wires
Downrod/Ball
Assembly
Pin in
Locked
Position
Locking Pin
Figure 7