Descargar Imprimir esta página

Publicidad

Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

Chemical-free Cleaning System High Capacity Unit
INSTALLATION & START-UP GUIDE
Filter Cartridge
Performance Indicators
BOOSTER ON/OFF
FLOW
OFF/ON Switch
COLD WATER IN
INSTALLATION INSTRUCTIONS
1.
Carefully remove all of the items from the carton.
2.
Remove mounting hardware from plastic package.
Four anchors with four No. 10 1" screws, Cold Water In hose with fittings, Liquefied Ozone Out hose, and Drain hose.
3.
Attach unit to wall using 4 screws in flanges top and bottom. If mounting to drywall, attach to 1/2" plywood backer board to wall
before mounting High Capacity unit.
4.
Attach hose with fittings to COLD WATER IN barbed fitting, making sure that clamp is tight enough to secure hose.
5.
Attach hose without fittings to LIQUEFIED OZONE OUT barbed fitting - clamp is not required.
6.
Attach drain hose to DRAIN fitting if desired - clamp is not required.
7.
Plug into grounded 110 volt power source.
START-UP INSTRUCTIONS
1.
Install the High Capacity unit as per INSTALLATION INSTRUCTIONS above.
2.
Make sure the power cord is plugged into 110v power outlet.
3.
Ensure COLD WATER IN hose is attached to open faucet or permanent cold water source.
To start, press FLOW switch to ON position.
4.
5.
When SYSTEM READY indicator is GREEN, dispense into mop bucket, auto scrubber, carpet extractor or spray bottle.
Press BOOSTER ON/OFF to GREEN for extended cleaning and sanitizing power. Booster will extend cleaning time from
6.
45 to 120 minutes and sanitizing time from 15 to 40 minutes.
Shut unit off when not in use by pressing FLOW switch to OFF position.
7.
WARNING: Never block or restrict LIQUEFIED OZONE OUT hose with nozzle, clamp or shut-off valve. This may damage unit and will
void the warranty. Always use FLOW ON/OFF switch to start or stop flow of Liquefied Ozone.
COLD WATER IN
hose
www.tersanoprofessional.com
1-800-727-8835
Chemical-free cleaner, stain-remover, deodorizer
and sanitizer.
System Ready
System Charging
Water/Ozone Low
Replace Filter
BOOSTER ON/OFF
FLOW
OFF
ON
TO OPERATE:
1. To start Press FLOW to ON.
2. Dispense when SYSTEM READY is GREEN.
3. Press BOOSTER ON/OFF to GREEN for extra strength.
4. Press FLOW to OFF when not dispensing.
DRAIN
LIQUEFIED OZONE OUT
DRAIN
Backer Board
(if required)
LIQUEFIED OZONE OUT
hose
HCUIG R1.0 02/10

Publicidad

loading

Resumen de contenidos para Tersano LOTUS PRO

  • Página 1 Chemical-free Cleaning System High Capacity Unit INSTALLATION & START-UP GUIDE Filter Cartridge Backer Board Chemical-free cleaner, stain-remover, deodorizer and sanitizer. (if required) Performance Indicators System Ready System Charging Water/Ozone Low Replace Filter BOOSTER ON/OFF BOOSTER ON/OFF FLOW TO OPERATE: 1. To start Press FLOW to ON. 2.
  • Página 2 Ozone for the purpose of cleaning, removing stains, deodorizing and killing germs. Do not open the unit as this will void the warranty – contact your supervisor or call Tersano Toll Free at 1-800-727-8835 for repairs or assistance if required.
  • Página 3 Sistema de limpieza sin sustancias químicas Unidad de gran capacidad GUÍA DE INSTALACIÓN Y ENCENDIDO Cartucho del filtro Chemical-free cleaner, stain-remover, deodorizer Panel de refuerzo and sanitizer. Indicadores de función (si es necesario) System Ready System Charging Water/Ozone Low ENCENDIDO / APAGADO Replace Filter del REFORZADOR BOOSTER ON/OFF...
  • Página 4 Si abre la unidad, la garantía quedará sin efecto. Póngase en contacto con su supervisor o comuníquese con Tersano llamando sin cargo al 1-800-727-8835 para solicitar el servicio técnico o asistencia, según sea necesario.