STAR Water Systems HSP10P1 Manual Del Usuario página 16

PUMP ELECTRICAL INSTRUCTIONS
4. Connect white power lead to L1 and black
power lead to L2.
5. Connect green ground wire to green
grounding screw. Re-install rear motor cover
to pump.
To change from 230 V to 115 V
6. The motor of pump is dual voltage and
can run on either 115 volts or 230 volts. In
general, 230 volts is more economical to run,
and requires a smaller wire size. The pump
is pre-set in the factory to run at 230 volts.
4
L1
5
L1
A
6
L1
A
16
L2
A B
L2
B
L2
B
GRAY
RED
IL1273
IL1274