Aqua EZ RVP31 Manual De Usuario página 7

Set-Up Before Use
Telescopic pole connector assembly
Press down the side pins of the connector/handle and insert it inside the main body.
Turn the connector in either direction until the pin is secured in the hole, as shown in
the diagram .
Telescopic pole assembly
Note: a V-clip is installed inside the pole connector to secure the telescopic pole (not
included) in position. Slide the telescopic pole onto the pole connector. Press on the
side pins of the connector and slide the telescopic pole further down until the pins of
the connector are secured inside the holes of the pole.
To release the telescopic pole, press down the side pins simultaneously and pull out
the pole.
Suction head assembly
Insert the suction head directly into the suction mouth of the pool vacuum until the
side tabs of the transparent case clip in the holes of the suction head's pivot.
NOTE: To replace the brushes on the suction head, lift one end and pull the brush out
to make space for a new one.
6