KTC FS40-12P Instrucciones página 9

GUARD & FAN BLADE ASSEMBLY
1. Unscrew the spinner clockwise (or take the spinner out from the bag) and the
plastic nut counter clockwise to remove both of them. Fix the rear guard to the
motor then tighten the plastic nut again. (Fig. 7)
2. Insert the blade into shaft, and make sure the rotor shaft pin is fitted into groove
of the blade. Turn the spinner counter clockwise to tighten the blade. (Fig. 8)
3. Fasten the front guard and the rear guard by the guard clip(Fig. 9)
Fig.7
OPERATING INSTRUCTION
1. SPEED CONTROL (Fig.10)
Fan speed is controlled by the switch :
0-1-2-3 (Off-Low-Medium-High)
2.OSCILLATION CONTROL (Fig.11)
To make the fan oscillate, press the clutch knob located on the
top of the motor housing. To get the directional airflow, pull the
clutch knob up to its initial position.
3.TILT ADJUSTMENT (Fig.12)
To adjust the air flow upward or downward, push the guards
lightly to the desired direction.
4.HEIGHT ADJUSTMENT
The height of the fan can be adjusted by loosening the locknut carefully raising or
lowering the fan and firmly re-tightening the locknut.
MAINTENANCE INSTRUCTION
The fan requires little maintenance. Do not try to fix it by yourself. Refer it to
qualified service personnel if service is needed.
1. Before cleaning and assembling, fan must be unplugged.
2. To ensure adequate air circulation to the motor, keep vents at the rear of the
motor free of dust. Do not disassemble the fan to remove dust.
3. Please wipe the exterior parts with a soft cloth soaking a mild detergent.
4. Do not use any abrasive detergent or solvents to avoid scratching the surface.
Do not use any of the following as a cleaner: gasoline, thinner, bending.
5. Do not allow water or any other liquid into the motor housing or interior parts.
Spinner
Spinner
Tight
Loose
Plastic nut
Blade
Fig.8
Tight
Slot
Retaining
Pin
Fig.9
9
Clip
3
2
1
0
Fig.10
Fig.11
Fig.12