Publicidad
Idiomas disponibles
Idiomas disponibles
Sep-System adjustable support
Once the structure has been adapted and fixed to the required measurements (with the shower tray mounted on top), it becomes part of the floor and will be both hidden
and inaccessible, with no need for further maintenance. Simply ensure that the SEP SYSTEM is correctly assembled, fixed in place and sealed according to the instructions
provided.
FAQ's (FREQUENTLY ASKED QUESTIONS)
SHOWER TRAYS
On using the shower tray for the first time I noticed that the water did not flow correctly despite the unit being correctly installed and levelled. During manufacture
and transport the trays may accumulate static electricity which can prevent the water flowing correctly at first. Once you clean the tray with soap, water and a cloth you will
notice this problem diminishing significantly. After a few uses the phenomenon will disappear completely.
The shower tray does not drain sufficiently despite being properly installed and levelled. This problem may be caused by a blockage to the waste or pipes, or perhaps
a second waste is in place. In any event, remove the stainless steel grate and extract the waste piece; if the problem persists, it is likely that the pipe is blocked; if the problem
disappears it means that a second waste exists, in which case the extracted piece should not be replaced.
What is the draining capacity of the trays? All trays have a maximum draining capacity for liquids of a similar viscosity as water up to 0.53 and 0.85 litres per second,
depending on the siphon installed.
What material is the grating made from? The gratings are made from as AISI 316 stainless steel cut using high definition lasers and polished on both sides.
The lacquered gratings are manufactured from AISI 340 stainless steel with a coat of heat sealed epoxy primer and finished in the desired colour.
How can I order spare parts? FIORA BATH COLLECTIONS S.L.U. keeps a stock of spare parts for all units. Please contact your local distributor for details.
Is it necessary to waterproof underneath the shower tray? Our shower trays are 100% waterproof. Except in the case of specific building requirements or regulations,
they do not require any additional sealing underneath, which is one of their main advantages over tiled floor showers.
Is any maintenance required for the shower tray after installation? We would only recommend that the waste screws are retightened (by lifting the upper grating) one
month after initial use.
SILEX COLLECTION SHOWER TRAYS
How is the siphon function removed? OPTION 1: The cylinder must be extracted, then remove the cap and shorten the cylinder by 15 mm to continue using the filter. After
doing so, reposition the cylinder and filter. OPTION 2: The cylinder must be extracted, then remove the cap using pliers. Do not replace the cylinder.
OPTION 1
1
OPTION 2
1
The shower tray shows some irregularities, are they manufacturing defects? No, these irregularities belong to the very surface texture of the shower trays which are
so characteristic of FIORA®.
Is it possible to repair SILEXPOL® units? All FIORA® shower trays manufactured using this material can be repaired after misuse. Areas where the surface paint has been
detached may be retouched and any holes or damage resulting from sharp objects may also be repaired.
Can the REPAIR KITS be put aside for later use? Repair kits are not designed for subsequent storing as the products supplied will evaporate or lose their properties. These
kits should be ordered for specific repair purposes and are only valid for one use
ELAX COLLECTION SHOWER TRAYS
The water does not drain sufficiently despite being properly installed and levelled. This problem may be caused by a blockage to the waste or pipes, or perhaps a
12
Privilege | Silex | Avant | Essential | Elax | Skin Panels
2
3
2
3
4
4
Publicidad
