Xtech UNIXON XTS-690 Manual De Instrucciones página 4

Description
8. 3.7V rechargeable
It is advisable to remove the battery from the battery
compartment when not using the microphone to avoid
lithium battery
damaging the unit. Replace the rechargeable battery
with one of the same specifications and quality from a
source or store you can trust.
9. LED status indicator
• When the receiver is turned ON the LED lights up in
blue (red light flashes slowly)
in the receiver
• When the microphone is entering into the pairing
mode the LED light starts blinking quickly in red
• When the pairing process is successful the light
blinks slowly in red.
10. Charging LED
• When the battery is charging the light turns red.
• When the battery is fully charged the light turns solid
indicator
green.
11. Adapter's ¼in input
Connect the 1/4in output jack to this port to be able to
plug the receiver in a 3.5mm microphone input port.
port
Refer to Fig. A
12. ¼in to 3.5mm input
Use this adapter to plug the rechargeable receiver to
the 3.5mm microphone input port of your selected
jack adapter
audio equipment. Refer to Fig. A
Function
FIGURE A
¼in OUTPUT
Note: Always connect the ¼in output jack or the ¼in to 3.5mm jack
adapter to a microphone input port, otherwise the microphone will not
work.
IV. How to use the microphone
• Place 2 AA batteries in the microphone´s battery compartment, making
sure the positive and negative ends are pointing in the right direction.
• Turn on the microphone by sliding the switch to the ON position.
• The display will light up indicating the microphone is on.
• Turn on the receiver by sliding the switch to the ON position. The LED
light turns solid blue and the red, indicating the pairing process is
successful.
3.5mm auxiliary ¼in microphone
input input