Troubleshooting - Xtech UNIXON XTS-690 Manual De Instrucciones

• Plug the rechargeable receiver ¼in output jack in the microphone´s input
port of your selected audio source, or use the ¼in to 3.5mm jack adaptor
to plug it in the 3.5mm microphone input port of your selected audio
equipment.
• Start enjoying the XTS-690 handheld wireless microphone right away.
Note: The microphone and the receiver will pair automatically. In case they
don´t, follow these steps.
• Press and hold the Reset button; the display will flash quickly.
• Turn the receiver on, the LED light will turn solid blue, the red LED will
flash quickly and then it will turn off, indicating that the microphone and
the receiver are already connected to each other.
• Press the Reset button briefly again, the display will stop flashing.
• The receiver LED light will turn solid red, indicating that the pairing
process is successful.
• Turn on the microphone. At this time it should start working.

Troubleshooting

Problem
There is no sound coming out
from the microphone
The display is not lighting up
The receiver´s signal indicator
light is not lighted up
Microphone is not pairing
There is a whistling noise
coming out from the
microphone
Solution
- Check if the microphone´s display, the receiver´s
signal blue light or red light are giving the correct
indication.
- Check if the microphone volume is set to its lowest
level in the devices.
Check if the batteries have been correctly placed or if
they need to be replaced.
Check if the batteries need to be replaced or haven´t
been correctly placed.
Check if the battery voltage is too low.
Lower the volume of the microphone
Maintain a longer distance between the microphone
and the sound source.