Shelly MOTION Manual De Instrucciones página 6

Shelly Motion has a built-in 6500mAh rechargeable battery which
allows the sensor to be connected to the Internet (standby mode)
for up to 3 years without recharging, and in active transmission
(approx. 6 hours/day motion detected) estimated between 12 and
18 months.
Specification
• Working temperature -10 ÷ 50°C
• Radio protocol WiFi 802.11 b/g/n
• Frequency 2400 – 2500 MHz
• Operational range (depending on local construction) up to 50 m
outdoors or up to 30 m indoors
• Battery - 6500mAh 3,7V
Visual indications
The Motion Sensor is equipped with a LED diode, signaling sen-
sor's operating modes and alarms.
Blue light non blinking
Red light blink
Green light blink
Blue/Green/Red sequence
Blue light blink
Blue light single blink
Button user interaction
Use pin to press the button as shown at the picture
• Short press (AP mode) - wake-up from AP sleep mode (AP is
only for 3 minute and device power OFF, battery save transpor-
tation mode)
• Short press (STA MODE) - send status
• Long press 5 sec (STA mode) - AP mode
• Long press 10 sec (STA mode) - Factory reset
6
ENGLISH
Inclusion mode
Motion detected and reported
Motion detected, reporting disabled
Reboot or Vibration detected
Firmware update
Settings change
User and Safety guide EN