After Use - JVC HA-W1000RF-J/C Manual De Instrucciones

6. Adjust the volume control of the connected AV equipment and the
headphones, and set them to the desired listening level.
At the same time, adjust the ear pad angle to make it fit comfortably.
In case of interference or too much noise
(e.g. when used near a cordless phone or
any other transmission device), set the
transmitter's CHANNEL to a different
position. To re-tune the headphone,
remove once and wear again.
To set optimum signal reception, adjustments
should be done within a range of approx. 23ft.
(7 m) between the transmitter and the
headphones.
Tips for better use
For improved sound quality, set the volume level of the connected equipment as high as
possible without causing distortion, while setting volume level of the headphones to a
slightly lower level. In surround mode, have the mode turned on while making the
adjustments as surround mode tend to distort more than normal mode.
The power turns off by removing the headphone from head. When sound signal is not
received for two minutes, the transmitter is set to turn off automatically. Recharge the
headphone after use.
Notes:
1. When using the headphones, don't raise the volume excessively. Continuous listening
for a long time at high volumes may damage your hearing.
2. For safety reasons, do not use the headphones while riding a bicycle or driving a
motorcycle, car, etc.
3. If the headphone is not used for a prolonged time, unplug the AC adaptor from an AC
outlet.
16
HOW TO USE
Within approx. 23 ft (7 m)
VOL.
MAX. MIN.

After use

1 2
CHANNEL
1 2
CHANNEL