Publicidad
Idiomas disponibles
Idiomas disponibles
Installing the Sanding Pad Holder or any other attachment 1. Lift up the quick-
change lever (1).
2. Attach the accessory (4-23) to the
multi tool.
3. Push down the quick-change
lever. Using the Attachment (e.g.)
1. Lift the quick-change lever (1).
Scraper)
2. Attach the scraper (e.g. 16) to the multi tool.
3. Check the correct fit of the attachment. Make sure the pins fit exactly into the openings of the
attachment.
4. Push down the quick-change lever. The attachments can be positioned in an angle of 30
to both sides of the multi tool, e.g. in line with the housing or on the right or left side of the
housing.
Attaching/Changing the Sanding Paper Pads
The sanding pad holder (21) is equipped with a hook and loop pad, so you easily and
conveniently can change the sanding paper pads (22). Keep the adhesive fabric of the
sanding pad holder free from dirt and dust, so the adhesive fabric will work as desired .
1. Position one corner of the sanding paper pad to the pad holder and firmly press it down.
For optimal dust extraction, make sure the holes in the sanding paper pad match the holes in
the sanding pad holder.
2. To remove the sanding paper pad, grasp one edge and pull it off the sanding pad holder.
EN
°
Publicidad
