Publicidad
Idiomas disponibles
Idiomas disponibles
1. Locate your RGBSplit close to the
computer.
2. Connect coaxial cable from the
monitor output of your computer to
the RED, GREEN, and BLUE input
connectors of the RGBSplit.
Depending on your computer and
monitor type, you may also need to
connect coaxial cables from the
computer to the input connectors
marked H/CS (Horizontal/Com-
posite Sync) and/or V (Vertical
Sync).
3. If you are using an adapter cable,
connect that adapter on the input
and/or output as necessary for the
computer type you are using.
RED
1
2
3
4
3. Installation
GREEN
1
2
3
4
Figure 1. The RGBSplit-4's rear panel.
4. Connect the monitor(s) to the
RED, GREEN, BLUE, H/CS, and/or
V outputs on the rear your RGBSplit.
Monitor extension cables
(EYNRGBS2) may be used to extend
the distance from the RGBSplit up
to 250 feet (76.2 m).
5. Plug the 9-VDC wall power
transformer into the jack on the rear
of your RGBSplit marked POWER.
6. Plug the power transformer into
a 110-VAC or 220-VAC wall outlet as
appropriate. The front-panel LED
should glow red to indicate that the
unit is properly powered.
7. Turn on the computer and the
monitor(s). The monitor(s) will
now display the computer's output.
BLUE
H/CS
1
2
1
3
4
3
Installation
V
2
1
2
4
3
4
POWER
7
Publicidad
