Motion Detect - Steren CCTV-971 Manual De Instrucciones

Motion detect

Select the channel for which you
want to activate the alarm by motion
detection and enable it.
Adjust the Sensitivity of the camera
and if you want, you can choose a
particular area in which the motion is
detected. By default, the entire area
of the camera is set to detect motion
(red).
To block an area, click on it so the red frame becomes transparent. When the setting of the
detection area is complete, give right click with the mouse to exit.
Period: Configure up to 4 periods for motion detection on specific days or for the entire week.
Interval: Select the time in seconds for the activation of the alarm after motion detection.
Record channel: Select the channel you want to record when the alarm is activated.
Tour: Select the scan feature for PTZ cameras.
PTZ Activation: Set the movement mode for PTZ cameras.
Record Delay: Choose the time in seconds that will start the PTZ camera motion after motion
detection.
Show message, Send Email, and Buzzer: Enable or disable these warnings.
FTP upload: Enable to save the recordings on an FTP server.
27 27