About Installation - Flotec FPPC-5800 Manual Del Propietário

Installation

ABOUT INSTALLATION

Please use the convenient, water resistant, "Installation
Instructions" card.
Step 1: Install vacuum port door fitting
If there is no spring-loaded door on the vacuum port,
install the included cover.
If you pool only has a skimmer, and no dedicated vacu-
um port, proceed to Step 2.
Figure 1
1. Screw the fitting into the port opening.
2. Orient the fitting so the arrow on the door points up.
3. Secure the cover by tightening the allen-screw below the
door.
Step 2: Straighten hose (Figure 2)
Remove and uncoil the hose from the carton. Lay it out
in the sunlight, flat and straight.
Figure 2
For parts or assistance, call Flotec Customer Service at
Step 3: Check parts (Figure 3)
• Cleaner assembly
• Black plastic swivel assembly
• Handle adapter
• White rubber reducer cone
• Hoses: 20', 8' and 4'
• White plastic vacuum regulator
• Cap for regulator
• Vacuum port fitting
• Flow gauge
Handle
Figure 3
Step 4: Clean filter system (Figure 4)
Backwash and clean filter; rinse; clean all baskets, etc.
Start pump.
1882 0795
Figure 4
Cleaner
Hose
4'
8'
20'
Vacuum
Port
1902 0795
1-800-365-6832
4
Swivel
Reducer
Ass'y
Cone
Flow
Gauge
Regulator
Regulator
Cap
1880 0795