Symmons Identity SLC-6710-1.5 Manual De Funcionamiento Y Mantenimiento página 3

Installation
If replacing an older faucet
ensure water supply is turned
OFF before removing, then
turn faucet control valve ON
to relieve water pressure.
DO NOT use pipe dope
or thread sealant on drain
assembly, or any plastic
threaded components.
1) Insert IPS inlet connections (I) and
mounting gasket (J) into sink holes.
2) Install mounting nuts (K) onto IPS
inlet connections (I).
1
K
1
1
1
3) Seat flange (L2) into sink. Install
gasket (L4), washer (L5) and nut
(L6) onto flange from below sink,
but do not secure nut. Screw on
tail piece (L7) and hand tighten.
PLUMBER
PUTTY
OPTIONAL
I
J
4) Turn tail piece (L7) and flange (L2)
so pivot is facing toward faucet.
Pull assembly down into drain hole.
Secure hardware from below sink.
Install stopper (L1) in the remov-
able or non-removable position.
L1
I
L2
2
L7
1
L2
L3
2
2
L4
L5
L6
L7
3
3
2
PIVOT
1
3
5) Attach inner washer (L8), pivot rod
(L9) and outer washer (L10) to tail-
piece (L7). Hand tighten nut (L11)
to secure pivot rod (L9).
L10
L8
L9
L7
6) Connect lift rod (E) to clevis strap (L13)
and secure with thumb screw (L14).
Insert pivot rod (L9) through spring
clip (L12) and clevis strap (L13).
Secure with spring clip (L12) and
adjust linkage if necessary.
1
L13
L9
L12
L11
E
L14