Publicidad
Enlaces rápidos
Models/Modelos/Modèles
P130LF, P131LF, P135LF, P135LF-W,
P136LF, P136LF-M, P138LF-M
Series/Series/Seria
Write purchased model number here.
Escriba aquí el número del modelo comprado.
Inscrivez le numéro de modèle ici.
You may need / Usted puede necesitar / Articles dont vous pouvez avoir besoin
Read all instructions prior to installation.
Lea todas las instrucciones antes de hacer la
instalación.
Veuillez lire toutes les instructions avant
l'installation.
Sink Hole Dimensions
Dimensiones del Hoyo Fregaderos
Dimensions des orifices de I'évier
(102 mm)
1-1/8" Dia.
(29 mm)
1"Dia.
(25 mm)
?
1-800-438-6673
www.peerlessfaucet.com
6/03/2019
4"
2"Max
1-1/8"Max.
(51 mm)
(29 mm)
86583
P131LF
P130LF
86583
1
SINGLE HANDLE CENTERSET
BATHROOM FAUCET
LLAVE DE AGUA MONOMANDO
PARA BAÑOS
ROBINET DE SALLE DE BAIN,
UNE MANETTE, ENTRAXE COURT
P136LF / P136LF-M
P135LF / P135LF-W
Hex key (1/8")
P138LF-M
86583 Rev. E
Publicidad
Manuales relacionados para PEERLESS P130LF
Resumen de contenidos para PEERLESS P130LF
- Página 1 86583 BATHROOM FAUCET LLAVE DE AGUA MONOMANDO PARA BAÑOS ROBINET DE SALLE DE BAIN, Models/Modelos/Modèles UNE MANETTE, ENTRAXE COURT P130LF, P131LF, P135LF, P135LF-W, P136LF, P136LF-M, P138LF-M Series/Series/Seria P131LF P138LF-M P136LF / P136LF-M Write purchased model number here. Escriba aquí el número del modelo comprado.
- Página 2 Slide washers (1) in place under sink and between nuts, with slotted SHUT OFF WATER SUPPLIES. Disconnect and remove old faucet. openings around tubes. Secure faucet to sink by tightening nuts (2) with a Place gasket (1) on bottom of new faucet. Assemble nuts (2) to studs. wrench.
- Página 3 Attach horizontal rod (1) to strap (2) using clip (3). Insert lift rod (4) into strap Remove pivot nut (1). Install horizontal rod (2) and stopper (3) as removable (4) and tighten screw (5). Connect assembly to drain (6). or non removable (5). Hand tighten pivot nut (1). Quite la tuerca del pivote (1).
- Página 4 Attach horizontal rod (1) to strap (2) using clip (3). Install lift rod (4), tighten Remove pivot nut (1). Install horizontal rod (2) and stopper (3) as removable (4) screw (5). Connect assembly to drain (6). or non-removable (5). Hand tighten nut (1). Quite la tuerca del pivote (1).
- Página 5 Pull grid strainer straight down into drain hole and secure gasket, washer Apply silicone sealant to underside of grid flange (1). Insert grid strainer and nut (1). DO NOT TURN GRID STRAINER WHILE TIGHTENING NUT assembly (2) up through bottom of lavatory. Screw grid flange back on OR SEALANT MAY NOT SEAL DRAIN.
- Página 6 Care Instructions Care should be given to the cleaning of this product. To clean: • Wipe gently with a damp cloth. • Blot dry with a soft towel. ® WARNING: SCRUBBING BUBBLES BATHROOM CLEANER and ® LYSOL BASIN TUB AND TILE CLEANER must not be used on the clear knob handles and levers.
- Página 7 RP70194 ▲ Handle w/Set Screw & Button RP70204 Manija con Tornillo de Ajuste Knob Handle w/Button, Screw, y Botón Connector and Set Screw Manette avec Vis de Calage Perilla con Botón, Tornillo, et Bouton Conectador y Tornillo de Ajuste Manette Sphérique avec Bouton, Vis et Vis de Calage Adjusting Ring Anillo de Ajuste...
- Página 8 Pièces et finis. Tous les pièces (autres que les composants électroniques et les piles) et les finis de ce pour toutes les demandes en vertu de la garantie, sauf si le produit a été enregistré auprès de Peerless robiGarantie limitée des robinets Peerless®...