Machine Components; Machine Operation; General Surface Drying; Sub-Surface Carpet Drying - Tennant 200 Manual De Operador Y Lista De Repuestos

MACHINE COMPONENTS

3
8
2
1. On/Off Two Speed Switch
2. Adjustable Legs
3. Carrying Handle
4. 5 M Power Cord
5. Power Cord Hook
6. Cord Grip
7. Intake Screen
8. Exhaust Snout

MACHINE OPERATION

FOR SAFETY: Do not operate machine unless
operator manual is read and understood.
1. Connect power supply cord into a grounded wall
outlet.
Grounded Outlet
Grounding
Edge/hole
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not use machine with the use of
an extension cord.
4
5
7
1
4
6
Home Find... Go To..

GENERAL SURFACE DRYING

1. Place dryer in a corner pointing toward center of
room. Adjust front legs to desired height.
2. Activate ON/OFF switch by selecting desired
speed. The forced air will dry surfaces rapidly.
3. Relocate dryer as surface dries.
SUB–SURFACE CARPET DRYING
Use this method for flooded carpets. This method
does not apply to carpets that are glued in place.
ATTENTION: Depending on carpet type, we
recommend that you seek professional advice
before attempting this method.
1. Remove all furniture from flooded area.
2. Remove surface water with an extractor.
3. Lift one corner of carpet from tack strip and fold
back approximately one meter.
4. Place the dryer in the corner and position the
exhaust snout under the carpet pinting toward the
center of room. Make sure intake screens are not
blocked.
5. Activate ON/OFF switch by selecting desired
speed. The forced air will billow the carpet in the
center of the room.
6. Operate dryer until carpet is dry.

MACHINE MAINTENANCE

WARNING: Hazardous Voltage. Shock or
electrocution can result. Unplug machine before
servicing.
WARNING: To reduce the risk of fire or
electrical shock, do not use this fan with any
solid–state speed control device.
1. After each use wipe power cord with damp cloth
and always wind cord around cord hooks rather
than loosely looped over machine. Also, check
power cord for damage, if worn or damaged,
replace immediately.
2. Each month clean dryer exterior with an
nonabrasive, non solvent cleaner.
3. Each month clean intake screens of any
accumulated lint or debris.
4. Each year remove intake screens and clean
blower wheel, motor and intake screens with an
air hose.
200 (02–01)