Descargar Imprimir esta página

Giagni IC-1W Manual Del Usuario página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

Install Door and Door Hardware
Place the hinge so that it is flush with the edge of
the door as show, and the metal plate when
upright is ½" from the edge of the door.
Based on room layout, determine which side of
the cabinet to install the door hinges. Lay the
cabinet down on that side. Lay DOOR upside
down next to cabinet, centered on the cabinet.
The pointed ears on the HINGE should rest along
the edge of the cabinet and there should be
about a ½" gap between the door and cabinet.
Drill 3/32" pilot holes, ¼" deep and secure the
two HINGES with four ROUND HEAD SCREWS.
Install magnetic CATCH within the upper
storage area on the side opposite the hinges
as shown. The plastic face surrounding the
magnet should be flush with the cabinet
edge. Drill 3/32" pilot holes ¼" deep and
secure with two ROUND HEAD SCREWS.
Install PLATE on door using
two FLAT HEAD SCREWS
so that the magnetic catch
hits the center of the striker
1/2"
when the door is closed
½"  
Flush
1"
2"
Install Clothes HOOK
using two FLAT HEAD
SCREWS in the upper
corner of the DOOR as
shown
For Recessed Mounting ONLY
If it is unknown if there is plumbing or electrical
inside the wall, use the Surface Mount option.
Recess Cabinet In Wall
Use the mark to locate the top of the cabinet. Use stud finder
to locate the nearest stud to either side. Cut opening in the
wallboard as shown. Slide the Ironing Center cabinet into the
opening. Use shims to level unit, and to apply light pressure on
both sides against the wood studs. Drive two WALL SCREWS
through the sides of the cabinet, though the shims and into the
wood studs about 6" down from the top of the cabinet.
For Surface Mounting ONLY
Hang Cabinet On Wall
Use the mark to locate the top of the
cabinet. Find the nearest stud center.
Choose the hole in the upper support
bracket that places the cabinet in the best
location, and drive a WALL SCREW through
that hole and into the center of the stud.
Place Ironing Board Inside Cabinet
Fold ironing board assembly as shown for the mounting method chosen. Place into
cabinet and align the side bracket holes with the pre-drilled holes in the sides of the
cabinet.
Cabinet Height
Mark
42-1/2"
14-1/2"
Cabinet Height
Stud Center Mark
Mark
Use hole closest to stud
center. Move cabinet so
hole is at the stud center.
Drive screw into stud center
Configuration
For Low-Wall
Mounting
Pull bar up to
unlock and
configure ironing
board assembly
Configuration
For High-Wall
Mounting
Floor

Publicidad

loading

Este manual también es adecuado para:

Ic-1wm