Explication Of Warning Symbols; Intended Use; Safety Instructions - IKA R 2722 Manual De Instrucciones

Explication of warning symbols

/// Warning symbols
Danger!
Indicates an (extremely) hazardous situation, which, if not avoided, will
result in death, serious injury�
Warning!
Indicates a hazardous situation, which, if not avoided, can result in
death, serious injury�
Caution! Indicates a potentially hazardous situation, which, if not avoided, can
result in injury�
Notice!
Indicates practices which, if not avoided, can result in equipment damage�
!
/// General Symbols
A–––
Position number
Correct / Result!
Shows the correct execution or the result of an action step�
Wrong!
Shows the incorrect execution of an action step�
Note!
Displays action steps that require particular attention to detail�
Closed lock!
Indicates the status of "locked"�
Open lock!
Indicates the status of "Unlocked"�

Safety instructions

!
/// General information
› Read the operating instructions completely before starting up and follow the safety
instructions.
› Keep the operating instructions in a place where it can be accessed by everyone�
› Ensure that only trained staff work with the device�
› Follow the safety instructions, guidelines, occupational health and safety and accident
prevention regulations�
› Install the stand on a flat, stable, clean, non-slip, dry and fire-resistant surface�
› The device must only be used in a technically perfect condition� The correct functioning of
the stand must be checked at regular intervals�
› Prior to each use, always check the stand, stirrer/disperser and accessories for damage�
Never use damaged parts�
10
› You must also follow the safety instructions contained in the operating instructions for the
stirrer or disperser�
› Check that the stirrer / disperser is installed correctly before use and at regular intervals�
Caution!
› Check the mounting position of the stirrer / disperser to avoid the danger of the unit tipping over�
› Observe the maximum permissible load-bearing capacity (see "Technical data")�
› The adjustment screw can be used to compensate for unevenness on the set-up plate� Use
the lock nut to lock the adjustment screw�
Notice!
!
› Pay attention to the marked sites in Fig� 1 and Fig� 2�
/// Telescopic stand R 2723
Caution!
› When adjusting the height of the movable stand rod, ensure that nothing becomes caught
between the devices or other objects attached to the bracket, e�g� the lower end stop or lip
of the container�
› The stand rod must be held in place when loosening the knurled screw (avoid rapid increases)�
› Always store the stand in a relaxed state�

Intended use

The R 2722 H-stand and the R 2723 Telescopic stand are suitable for large, heavy devices and
attachments that require absolute stability�
The R 2723 Telescopic stand should only be used to hold, raise and lower stirrers and dispersers�
With the pneumatic spring stand rod, instruments and attachments can be raised and lowered
smoothly and without difficulty�
The safety of the user cannot be ensured:
› if the stand is used in conjunctions with accessories not made or recommended by the
manufacturer
› if the stand is not used for the intended purpose as specified by the manufacturer�
11