Usage - Klarstein 10030135 Manual Del Usuario

Placement
• Remove all packaging materials including bottom cushions and foam pads and tapes inside the freezer,
Tear off the protective film on the door and the freezer body.
• Keep away from heat and avoid direct sunlight. Do not place the freezer in moist or watery places to pre-
vent rust or reduction of insulating effect.
• The freezer is placed in a well-ventilated indoor place. The ground must be flat and sturdy.
• The top space of the freezer shall be greater than 70 cm, and the distances from both sides and the back-
side must be more than 20 cm to facilitate the opening and clising and heat dissipation.
• Wipe the freezer inside and outside with a warm moist rag (add a small amount detergent in the warm
water and wipe clean finally with clean water).
• The freezer must stay for half an hour before connecting 220-240 V~) / 50 Hz) power when it is firstly
started.
• The freezer shall run 2 to 3 hours before loading fresh or frozen foods. The freezer must run for more than
4 hours in summer in advance considering that the ambient temperature is high.
Adjustment of the thermostat
• Connect the freezer to the power supply and the
POWER indicator will light. The RUN indicator will
shine in operation.
• The ALARM indicator light will shine when the tem-
perature is too high.
• The temperature of the freezer compartment is
adjusted by the thermostat knob. the numbers
1,2,3,4,5,6 do not mean a specific temperature, the
lower the number is, the higher the temperature
inside will be and vice versa.
• OFF: The appliance is out of operation

Usage

Power
4
3
Run Alarm
5
6
0FF
1
2
16