Publicidad
Idiomas disponibles
Idiomas disponibles
CONVERT BAKE BURNER ORIFICE
(Model CGY366 only)
Refer to Installation Instructions.
Hold-Down Screws
Brackets
forward and set
aside.
screw.
E. Lift the front of the
slide forward setting
Burner Screw
G. Adjust the shutter setting
Bracket
per the chart.
Orifice
you replace spreader within
Burner and Spreader
use.
CONVERT BROIL BURNER
ORIFICE (Model CGY366 only)
Broil Element
Screws
Burner Screw
Spreader
Screws
Broil Element
Screws
C. Pull electric elements
out until terminals reach
Lower front edge of
Screws.
Screw and then
G. Adjust the shutter setting per
the chart.
Bottom
element. Place the unused
future use.
ADJUSTING AIR SHUTTER SETTINGS
FOR OVEN BURNERS (Model CGY366 only)
AIR SHUTTER
BURNER
SETTING FOR PROPANE
Bake
Broil
3. Turn on the electricity.
shutter more.
WARNING
If you attempt to measure the inner cone of
Spreader
Screws
adjustment to the bake buner is required. Normal
on the type of gas you use. With propane gas, some
Foreign particles in the gas
Broil
Element
line may cause an orange
soon disappear.
9. When all adjustments are
made and the results are
satisfactory:
a. Retighten the air
shutter screws.
CHECK SURFACE BURNERS
indicates proper operation of the ignition system. When lighting
from only the one selected. Once air is purged from the supply
Quality of Flames
AIR SHUTTER
SETTING FOR NG
or air.
Screw
ADJUSTING LOW FLAME SETTING
Air shutter
ON COOKTOP BURNERS
SPECIALTY BURNERS
Multi-Ring Burner – The outer ring of
outer shaft while turning inner screw.
(A) Yellow flames:
Further Adjustment
Required
(B) Yellow tips on
outer cones:
Normal for Propane Gas
(C) Soft blue flames:
Normal for Natural Gas
Adjustment screw
for outer ring
screw to access
adjustment screw
for inner ring
(A) Soft blue flames—
Adjustment screws for
Normal for natural gas
SPECIAL NOTE:
outer cones—
Normal for propane gas
ADDITIONAL INFORMATION
BURNER OUTPUT RATINGS: BTU/HR
NG (Natural) Gas 5" W.C.P.
BTU
BURNER
RATE
LF
C
C1
C3
RF
198
Denotes 1.98mm Orifice size opening
N
Denotes Natural Gas
III
PROPANE CONVERSION INSTRUCTIONS
31-2000802 Rev. 5 05-21 GEA
CGY366, C2Y366, C2Y486, CGU366, CGU486
Burner Cap
Flames
Hold
Adjustment screw for
ORIFICE
MARKING
SIZE
N/A
N/A
N/A
N/A
1.98 mm
198N
Publicidad
