ERMILA 1585 Traducción Del Manual De Uso Original página 12

ENGLISH
Operation
de
Preparation
Keep the packaging material for safe storage or
en
transport later.
f Check that the delivery is complete.
fr
f Check all the parts for possible transport damage.
it
Safety
Handle with care! Damage due to incorrect power
supply.
es
f Only operate the appliance with an alternating cur-
rent and with the voltage stated on the nameplate.
pt
Charging the battery
Before the appliance is used for the first time, it
nl
should be charged for approx. 2 hours!
sv
1. Connect the appliance plug (K) on the plug-in transformer to
the charging stand socket (F) (Fig. 4ⓐ).
no
The appliance can also be connected directly to the
plug-in transformer for charging (Fig. 2ⓐ/ⓑ).
Battery overcharging is prevented thanks to intelligent
fi
charge management.
tr
2. Connect the plug-in transformer to the mains socket
(Fig. 4ⓑ).
3. Switch off the appliance using the on/off switch (Fig. 3).
pl
4. Place appliance in the charging stand (Fig. 4) or connect
directly to the plug-in transformer (Abb. 2ⓐ/ⓑ).
cs
· During the charging operation, the LED on the
on/off switch flashes at evenly spaced intervals.
sk
When the battery is fully charged, the LED flashes
at a different rate (10 on / 1 off).
· After the device has been removed from the
hu
charging stand, the display goes out after approx.
15 seconds (power saving mode).
It takes no more than 120 minutes for the appli-
·
sl
ance to charge to full capacity.
ro Battery operation
1. Switch on the appliance using the on/off switch and switch
off after use (Fig. 3).
bg
· When the battery is fully charged, the appliance
ru
can be used for up to 100 minutes without mains
connection. This capacity is attained after approx.
5 - 10 charging cycles.
uk
· In case of insufficient maintenance of the
blade set, the operating time can be reduced
considerably.
el
ar
12
Mains operation
1. Connect the appliance plug (Q) on the plug-in transformer
to the appliance socket (F) (Fig. 2ⓐ).
2. Connect the plug-in transformer to the mains socket
(Fig. 2ⓑ).
3. Switch on the appliance using the on/off switch and switch
off after use (Fig. 3).
Operation
Cutting with the attachment comb
The appliance can also be operated with an attachment comb.
f The attachment comb has 5 detent positions for adjusting
the length of cut.
f The further the attachment comb is pushed in (retracted),
the shorter the length of cut.
The length of cut can be adjusted from 3 mm
(Abb. 6ⓐ) to 6 mm (Fig. 6ⓑ).
Attaching/removing the attachment comb
1. Slide the attachment comb on to the blade set in the direc-
tion of the arrow until it reaches the limit stop (Fig. 5ⓐ).
2. The attachment comb can be removed by pushing it in the
direction of the arrow (Fig. 5ⓑ).