Conceptronic DDE02B Instalación-Utilización página 3

Note: The capacity of the destination disk should be equal or larger than the source
disk. Make sure that those hard disks have no bad sectors. Bad sectors will cause
unpredictable problems.
 Put the source disk into the HDD A bay, then, put the destination disk into the HDD
B bay. Please make sure that those hard drives are correctly and firmly connected
to those SATA connectors of the docking station.
 Connect the power adapter to the docking station and power outlet.
 Press the power button to power up the docking station.
 Wait at least 10 seconds till the docking station is prepared.
Note: If you have important data on the hard disk, please back up the data before
beginning the Clone operation.
 Keep pressing the Clone button for 3 seconds to begin duplication.
During the Clone process, those LED indicators will flash to show the percentage of
the progress:
Begin Clone process: 4 LEDs flash one by one.
Green LED stays solid: 25%
Red LED stays solid: 50%
Yellow LED stays solid: 75%
Orange LED stays solid: 100%
When the green, red, yellow & orange LEDs all stay solid, the process of the Clone
had been finished.
Note: Those hard drives may become hot during the Clone process.