Kobalt 0056643 Manual De Instrucciones página 11

ASSEMBLY INSTRUCTIONS
13. Screw one end of wall strap (EE) to
the upper side of back (A) with
#8-32 x 3/8 in. bolts (BB) and #8-32
nuts (CC). Secure the other end to the
wall with ST4 x 20 mm screws (DD).
Note: This cabinet should be anchored to
the wall using the wall strap (EE) to avoid
any potential danger from cabinet falling.
Check and see if the top (D) is level. If not
level due to uneven floor, the two doors
will probably not be properly aligned. In
this case, use an adjustable wrench (not
included) to adjust the hex nut until the
top (D) is level.
Hardware Used
#8-32 x 3/8 in. Bolt
BB
#8-32 Nut
CC
ST4 x 20 mm
DD
Screw
OPTIONAL K-RAIL MOUNTING INSTRUCTIONS
1. Ensure wall studs are plumb and
square. Place the K-Rail
#0103683, sold separately) on the wall
studs at the desired location, with the
center of the K-Rail
30-1/2 in. from the floor. Level the
®
K-Rail and mark the location. K-Rail
must be attached to a minimum of 3
wall studs. Attach the K-Rail
wall studs at the marked locations
using two wood screws (not provided)
per stud.
x 2
x 2
x 2
®
(Item
®
a minimum of
®
®
to the
13
D
A
EE
Wall strap
1
11
EE
Wall
EE
CC
DD
BB
x 1
Minimum
30-1/2 in. from
the floor
Lowes.com