Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PLS530A/PLS531A
5. SELECTING THE OPERATING MODE
The programmable switch has 2 operating modes: manual (MAN) and automatic
(AUTO). To switch mode, press the switch door for 3 seconds.
Manual Mode
The programmable switch operates as a regular switch. Briefly
press the switch door to turn the lights On or Off. The mode (MAN)
and state (ON or OFF) are displayed.
Automatic Mode
The programmable switch follows the programmed schedule. The
mode (AUTO), state (ON or OFF) and current program number are
displayed.
To temporarily override the programmed schedule, press the switch door. The new state
(ON or OFF) will flash to show that this state is temporary. The override remains in
effect until you press the switch door again or until the beginning of the next program.
6. PROGRAMMING
You can set up to 7 programs. To set a program, you need to enter its start time (ON)
and its end time (OFF).
1. Pry the switch door open using a small screwdriver.
2. Press the PGM button to display a program and its On or
Off time. For example, when you first press PGM, program
number 1 (P1) and its On time (ON) will appear. - : - - will
appear instead of the time if the program is not set (inac-
tive).
3. Press the DAY button to select the day to which you want
to apply the program.
NOTE:
If you want to apply the program to every day of the
week, press DAY until all the days are displayed. (This
still counts as 1 program, not 7)
4. Press the HOUR and MIN buttons to set the ON time (time when you want the
lights to turn on). If you have selected the 12-hour format, ensure that PM
appears on the screen when an afternoon time is displayed.
5. After you have programmed the ON time, press the PGM button to display the
OFF time (time when you want the lights to turn off).
6. Repeat steps 3 through 5 to program the OFF time. If the
program ON time is set for every day of the week, the pro-
gram OFF time will automatically be set for every day.
7. To set another program, repeat steps 2 through 6. Pro-
grams that are not set will remain inactive.
8. Press one of the control buttons or close the switch door to return to normal
operation.
Clearing a Program
Press the PGM button until the desired program is selected. Hold the PGM button for 3
seconds. - : - - appears when the program is erased.
7. TECHNICAL SPECIFICATIONS
Supply: 120 VAC, 50 / 60 Hz
Minimum load: 40 watts
Maximum load: 500 watts
Operating temperature range: 5°F to 122°F (-15°C to 50°C)
Storage temperature range: -4°F to 122°F (-20°C to 50°C)
Power outage: The programs are protected by a rechargeable battery. The screen is
blank during the power outage.
Certifications: CSA & UL
Resideo Technologies, Inc.
1985 Douglas Drive North, Golden Valley, MN 55422
www.resideo.com
69-2502EFS—07 M.S. Rev. 08-20 | Printed in United States
© 2020 Resideo Technologies, Inc. All rights reserved.
This product is manufactured by Resideo Technologies, Inc. and its affiliates.
Tous droits réservés. Ce produit est fabriqué par Resideo Technologies, Inc. et ses sociétés affiliées.
Todos los derechos reservados. Este producto es fabricado por Resideo Technologies, Inc. y sus afiliados.
TROUBLESHOOTING
• Verify circuit breaker at main panel.
Blank display
• Verify if light bulb is burned out
• Ensure the ON/OFF selector is at ON.
• Reset the switch using a paper clip.
• Load is less than 40 W
Faded or irregular
• Ambient temperature is below freezing point
display
Cannot switch
First, press one of the control buttons so that MAN or AUTO
between 24-hour
appears on display.
format and
12-hour format
• Make sure the switch is properly programmed.
Programs do not run
• Note that - : - - indicates an inactive program, 00:00
as expected
indicates midnight.
• If the switch has been configured for 12-hour format,
check that PM appears on the left side of the screen when
an afternoon time is displayed.
The metal plate is hot This is normal with high loads (maximum of 500 W).
WARRANTY
Resideo warrants this product, excluding battery, to be free from defects in
workmanship or materials, under normal use and service, for a period of three (3) years
from the date of first purchase by the original purchaser. If at any time during the
warranty period the product is determined to be defective due to workmanship or
materials, Resideo shall repair or replace it (at Resideo's option).
If the product is defective,
(i) return it, with a bill of sale or other dated proof of purchase, to the place from which
you purchased it; or
(ii) call Resideo Customer Care at 1-800-468-1502. Customer Care will make the
determination whether the product should be returned to the following address:
Resideo Return Goods, 1985 Douglas Dr. N., Golden Valley, MN 55422, or whether a
replacement product can be sent to you.
This warranty does not cover removal or reinstallation costs. This warranty shall not
apply if it is shown by Resideo that the defect was caused by damage which occurred
while the product was in the possession of a consumer.
Resideo's sole responsibility shall be to repair or replace the product within the terms
stated above. RESIDEO SHALL NOT BE LIABLE FOR ANY LOSS OR DAMAGE OF ANY
KIND, INCLUDING ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING,
DIRECTLY OR INDIRECTLY, FROM ANY BREACH OF ANY WARRANTY, EXPRESS OR
IMPLIED, OR ANY OTHER FAILURE OF THIS PRODUCT.
Some states do not allow the exclusion or limitation of incidental or consequential
damages, so this limitation may not apply to you.
THIS WARRANTY IS THE ONLY EXPRESS WARRANTY RESIDEO MAKES ON THIS
PRODUCT. THE DURATION OF ANY IMPLIED WARRANTIES, INCLUDING THE
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE,
IS HEREBY LIMITED TO THE THREE YEAR DURATION OF THIS WARRANTY. Some
states do not allow limitations on how long an implied warranty lasts, so the above
limitation may not apply to you.
This warranty gives you specific legal rights, and you may have other rights which vary
from state to state. If you have any questions concerning this warranty, please write
Resideo Customer Care, 1985 Douglas Dr, Golden Valley, MN 55422 or call 1-800-
468-1502.
CUSTOMER ASSISTANCE
If you have any questions about your light switch, go to http://honeywellhome.com, or
call Resideo Customer Care toll-free at 1-800-468-1502.
Publicidad
Tabla de contenido
