Programming Instructions - Geba Tronic Cody Universal 2 Manual Del Usuario

Keypad
Programming
instructions
Please read first - then do the programming!!!
Before programming your Cody Universal 2 with your personal codes, please check the faultless
function of the appliance with the help of the factory's pass code 1234 and the button.
Usually, any programming is made via your personal mastercode. In order to get familiar with that kind
of programming, you start with the input of a new pass code, which replaces the one preset by the
factory (1234). The procedure is explained under item "Program 2".
After that please change the factory set mastercode to your personal code of choice.
Attention / Note
In case you made a mistake on programming, you can start over again by pushing the
button
Program 1
Input of a new mastercode
Factory setting = 1-8
Enter 8 digit
push
Sound signal
push
mastercode
2x long
button
button
Enter 8 digit
NEW
push
mastercode
Sound signal
1x long
button
The new mastercode is now saved!