Safety Instructions - Total TBG15015 Guia De Inicio Rapido

Safety Instructions

15) Disconnect tools.
When not in use, before servicing and
when changing accessories such as
blades, bits and cutters, remove the
mains plug from the socket.
16) Remove
wrenches.
Make the habit of checking to see that
keys and adjusting wrenches are removed
from the tool before turning it on.
17) Avoid unintentional starting.
Do not carry a plugged-in tool with a
finger on the switch. Ensure switch is in
the off when plugging in.
18) Use outdoor extension leads.
When tool is used outdoors, use only
extension leads approved for outdoor
use.
19) Stay alert
Watch what
common sense. Do not operate tool
when you are tired or under the
influence of drugs or alcohol.
20) Check damaged parts.
Before further use of the tool, a guard or
other part that is damaged should be
carefully checked to determine that it
will operate properly and perform its
intended function. Check for alignment
of moving parts, free running of moving
parts, breakage of parts, mounting and
any other conditions that may affect its
operation. A guard or other part that is
damaged should be properly repaired or
replaced by an authorised service
centre unless otherwise indicated in this
instruction manual.
switches replaced by an authorised
service facility. Do not use the tool if the
switch dose not turn it on and off.
21) Warning
The using
adjusting keys
you are doing.
Have defective
of any accessory
attachment,
recommended in this instruction manual
may present a risk of personal injury.
22)Have your tools repaired by qualified
person.
This electrical tool is in accordance with
and
the relevant
Repairs should only be carried out by
qualified persons using original spare
parts, otherwise this may result in
considerable danger to the user.
ADDITIONAL SAFETY INSTRUCTIONS
FOR BENCH GRINDER
1.Wear protective glasses.
2.Do not use damaged grinding wheels
only fit new recommended Grinding
Wheels. (old or second hand wheels
may have hairline cracks).
Use
3.Always ensure wheels rotate freely
before turning on.
4.Before use inspect wheels for chips or
cracks and discard if damage is
found.
5.Ensure paper Blotter between washer
and grinding wheel is in place and
undamaged, replace with a piece of
Blotting paper or thin card cut to
shape if required.
6.When fitting a new wheel ensure
blotters are in place, fit concave side
of washers to face the wheel and
tighten the lock nut firmly.
7.It is recommended that the bench
grinder is mounted to the suitable
work surface.
Important
grinder
or
3
other than
safety requirements.
Note: This
have to be
Always connect the plug
on the mains socket with
earthed.
those
bench
earthed.