Total TBG15015 Guia De Inicio Rapido página 5

Operation
Assembly Instructions
Before use, the
arresters must be fitted to the grinder.
Remove both
packaging, position the shields over the
two mounting
grinding wheels with the flanges of the
spark arrester facing away from you, fix
with the screw and washer provided. At
this stage do not fully Tighten, see dia2.
Work rest adjustment
Take the work rest out of the package,
fix on the grinder with the knob and
washer provided as shown in dia3. The
gap between the rests and the wheels
should be checked before use. Measure
the gap between the grinding wheel and
the rests; this should be as small as
possible not greater than 2 mm, if not,
loosen the two knobs on each of the
rests, set the correct gap and fully
tighten, see dia4. The gap must be
maintained as the wheel wears.
eye shields/spark
eye shields
brackets above
Dia2
from
the
Operating
Make sure grinder is securely mounted;
mounting holes are provided in the base
of the grinder for this purpose, but the
screws are not provided. Plug in the
mains supply and push the on/off switch
right to the on position. Switch off and
unplug the grinder when not in use.
Changing grinding wheels (dia5)
To change the grinding wheels, first
unplug from mains supply then remove
the eye shield brackets, then undo and
remove the three screws holding the
wheel guard covers in place. Remove
the cover. Undo and remove the two
wheels retaining nuts (a). You may have
to hold the wheel and give the spanner a
firm tap with a soft headed hammer to
release the nut, take off the large domed
washer(b), paper washer(c) and remove
the wheels(d).
5