Russell Hobbs 20570-56 Instrucciones página 66

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
Read the instructions, keep them safe, pass them on if you pass the appliance on. Remove all
packaging before use.
A IMPORTANT SAFEGUARDS
Follow basic safety precautions, including:
1 This appliance can be used by persons with reduced physical,
sensory or mental capabilities or lack of experience and knowledge
if they have been supervised/instructed and understand the
hazards involved. Children shall not play with the appliance.
2 Keep the appliance and cable out of reach of children.
3 Don't leave the appliance unattended while plugged in.
4 Unplug after use and before carrying out user maintenance.
$ Danger of scalding – the appliance issues steam and hot water.
5 Don't use the appliance for cleaning electrical equipment, e.g. the
inside of an oven.
6 Don't operate the appliance if it's dropped or damaged, or if it
malfunctions or leaks.
7 If the cable is damaged, it must be replaced by the manufacturer,
its service agent, or someone similarly qualified, to avoid hazard.
H Don't immerse the appliance in liquid.
8 Don't use the appliance outdoors.
9 Don't use accessories or attachments other than those we supply.
10 Don't use the appliance for any purpose other than those described in these instructions.
C USAGE
1 The appliance can be used on most tiled, carpeted, parquet, and laminate flooring.
2 The flooring must be correctly laid, without gaps or cuts that moisture could penetrate.
3 Don't use it on unsealed wooden flooring, glass, soft plastic, or leather.
4 Don't use it on waxed flooring – the wax may melt, damaging the appliance and the flooring.
5 Test it on an inconspicuous part of the flooring, and check for moisture penetration and/or
damage before proceeding.
, If in doubt, ask the supplier of the flooring for advice.
d ASSEMBLY
6 Remove the screw from the rear of the base.
7 Fit the body to the base.
8 Replace the screw through the hole at the bottom of the body.
9 Push the bottom of the shaft into the top of the body.
10 Rotate the shaft till the pip engages with the hole in the body.
11 Wind the cable round the cable hooks.
C THE CLOTH
12 Loosen the ties.
13 Fit the cloth over the base.
14 Bring the edges of the cloth up and over the flange running round the base.
15 Tighten the ties to secure the cloth to the base.
household use only
66

Publicidad

Tabla de contenido
loading

Tabla de contenido