Axis M10 Serie Guia De Instalacion página 3

This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful
interference, and
2. this device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested using a shielded
network cable (STP) and found to comply with
the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
•
Reorient or relocate the receiving
antenna.
•
Increase the separation between the
equipment and receiver.
•
Connect the equipment into an outlet on
a circuit different from that to which the
receiver is connected.
•
Consult the dealer or an experienced
radio/TV technician for help.
The product shall be connected using a shielded
network cable (STP) that is properly grounded.
Contact information
Axis Communications Inc.
300 Apollo Drive
Chelmsford, MA 01824
United States of America
Tel: +1 978 614 2000
Canada
This digital apparatus complies with
CAN ICES-3 (Class B). The product shall
be connected using a shielded network
cable (STP) that is properly grounded. Cet
appareil numérique est conforme à la norme
CAN NMB-3 (classe B). Le produit doit être
connecté à l'aide d'un câble réseau blindé (STP)
qui est correctement mis à la terre.
Europe
This digital equipment fulfills the requirements
for RF emission according to the Class B limit
of EN 55032. The product shall be connected
using a shielded network cable (STP) that is
properly grounded.
Australia/New Zealand
This digital equipment fulfills the requirements
for RF emission according to the Class B limit
of AS/NZS CISPR 32. The product shall be
connected using a shielded network cable (STP)
that is properly grounded.
Japan
この装置は、クラスB機器です。この装
置は、住宅環境で使⽤することを⽬的と
していますが、この装置がラジオやテレ
ビジョン受信機に近接して使⽤される
と、受信障害を引き起こすことがありま
す。 取扱説明書に従って正しい取り扱い
をして下さい。 VCCI ‒ B
本製品は、シールドネットワークケーブ
ル(STP)を使⽤して接続してください。ま
た適切に接地してください。
本製品は電気通信事業者（移動通信会
社、固定通信会社、インターネットプロ
バイダ等）の通信回線（公衆無線 LAN を
含む）に直接接続することができませ
ん。本製品をインターネットに接続する
場合は、必ずルータ等を経由し接続して
ください。
Korea
이 기기는 가정용(B급) 전자파적합기기로
서 주로 가정에서 사용하는 것을 목적으로
하며, 모든 지역에서 사용할 수 있습니다.
적절히 접지된 STP (shielded twisted pair)
케이블을 사용하여 제품을 연결 하십시오.
Radio transmission
This radio equipment operates at 2.4 and 5.2
GHz, with a maximum output power of 100 and
200 mW respectively.
This equipment may generate or use radio
frequency energy. The user could lose the
authority to operate this equipment if an
unauthorized change or modification is made.
USA
This product complies with FCC radiation
exposure limits for an uncontrolled
environment.
Canada
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1)
this device may not cause interference, and
(2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
This product complies with IC radiation exposure
limits for an uncontrolled environment.
This device for operation in the frequency
band 5150-5250 MHz is only for indoor use to
reduce the potential for harmful interference to
co-channel mobile satellite systems.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est